LIVING CO CL-5909 Ionic Hair Dryer Instruction Manual
- June 4, 2024
- LIVING CO
Table of Contents
LIVING CO CL-5909 Ionic Hair Dryer
TECHNICAL DATA
- Type: CL-5909
- Power: 220-240V ~ 50/60Hz
- Capacity: 1800-2200W
- Motor: DC
PRODUCT OVERVIEW
- A – Concentrator
- B – Cool switch
- C – Heater switch
- G – Diffuser
- D – Speed switch
- E – Cord guard with storage loop
- F – Removable inlet grille
SAFETY WARNINGS
- Do not switch on before checking that voltage on the specifications plates is the same as that in your home;
- Switch off when not in use, even if for a moment;
- If the supply cord is damaged, it must be replaced by the manufacturer of its service agent or a similarly qualified person in order to avoid a hazard.
- For additional protection, the installation of a residual current device with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
- Never submerge or wet the dryer.
- WARNING- When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- ®: Not to be used in bath or shower.
- WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- This appliance is intended to be used in households and indoors.
- Do not use the appliance with wet hands.
- Always ensure that the air inlet and output are not blocked during use.
HOW TO USE
- Make sure that your hands are completely dry before plugging in.
- Plug in and set the switch to the required position.
- Once your hair is dry set the switch ( D) to the off ‘O’ position and unplug the dryer.
Heater switch:
Position low temperature
Position medium temperature gentle drying and shaping
Position high temperature for rapid drying
Speed switch:
Position 0 off
Position a gentle stream of air
Position a strong stream of air
Cool switch:
with this switch, you can stop the heating and allow cool airflow
CLEANING
- WARNING- always unplug your appliance before cleaning.
- Your hair dryer requires very little attention. You can clean it together with its accessories, using a slightly damp cloth.
- The air inlet grille can be removed periodically as shown in the following image, use a damp cloth or vacuum to remove any dust deposits.
- Never clean your appliance with solvent-based cleaners or abrasive cleaners.
- Never immerse your appliance or its accessories in water.
- Carefully dry all parts you have just cleaned.
AIR INLET GRILLE REMOVAL
NOTE: Always ensure the grille is clean/dry and refitted before operating the appliance.
DISPOSAL
Correct Disposal of this product
This marking indicates that this product should not be disposed of with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Warranty
We pride ourselves on producing a range of quality home appliances that are
both packed with features, and completely reliable. We are so confident in our
products, we back them up with a 2-year warranty when accompanied with proof
of purchase. Now you too can relax knowing that you are covered.
Customer Helpline NZ: 080042227 4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>