living co YF-DE1201 30cm Table Fan Instruction Manual

living co YF-DE1201 30cm Table Fan Instruction Manual

Important Safety Instructions

READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
Read this manual thoroughly before first use, even if you are familiar with this type of product. The safety precautions enclosed herein reduce the risk of fire,electric shock and injury when correctly adhered to. Make sure you understand all instructions and warnings. Keep the manual in a safe place for future reference, along with any warranty information, your purchase receipt and the original packaging carton. If you sell or transfer ownership of this product,pass on these instructions to the new owner. Always follow basic safety precautions and accident prevention measures when using an electrical appliance, including the following:

Electrical safety and cord handling

• Voltage: Make sure your outlet voltage and circuit frequency correspond to the voltage stated on the rating label. If this is not the case, do not use the fan.
• Water: To protect against fire and electric shock, do not immerse the cord, plug or the fan itself in water or other liquids, or expose the electrical connections to water. Ensure your hands are dry before handling the plug or switching on the appliance. Do not use the fan outdoors or on wet surfaces. Protect it from liquid spills.
• Damage: Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by the manufacturer, its authorised service centres or appropriately qualified personnel in order to avoid any hazards. WARNING! Do not pick up or operate the appliance if the power supply cord, plug or housing is damaged, or after it malfunctions or has been dropped or damaged in any manner. In case of damage, contact our after sales support line for advice.
• Protect the power cord:
  • Do not operate the fan with the cord coiled up; always fully unwind.
  • Do not twist or kink the cord or let it touch heated surfaces.
  • Do not put any stress on the cord where it connects to the product.
  • Never carry the fan by the cord.
  • Arrange the cord away from any traffic area so no one will trip over it.
  • Do not run the cord under carpeting or cover it with rugs or runners.
• WARNING! No extension cord, no timer: Do not use the fan with an extension cord, plug adaptor, external timer or solid-state speed control device.
• Connection: To insert the plug, grasp it firmly and guide it into outlet.
• Disconnection: Switch off and unplug the fan from the power outlet when it is not in use, during lightning storms and before cleaning, servicing, moving or storing the fan. Grasp the plug and remove it from the outlet, do not pull the cord when disconnecting.
• RCD: Unless your home is already fitted with a residual current device (safety switch), we recommend installing an RCD with a rated residual operating current not exceeding 30mA to provide additional safety protection when using electrical appliances. See your electrician for professional advice.

Usage conditions and restrictions

• Domestic use only: This appliance is intended for indoor household use only. It is not suitable for commercial, industrial, trade or outdoor use. Do not use it for anything other than its intended purpose, and only use it as described in this manual. Any other use may cause fire, electric shock or injury.
• No clothes drying: Do not use this fan as a dryer.
• Attachments: The use of accessories not intended for use with this fan may cause injuries to the user or damage to the appliance.
• Liability: We assume no liability for any damages or personal injury caused by misuse of the product and/or failure to follow these instructions.
• Usage restriction: This fan is not intended for use by children and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children: This fan is not a toy. Supervise children to ensure they do not play with ft. Close supervision is necessary when any appliance is used by or near children.
• WARNING Do not leave unattended during use! Always switch it off and unplug when not in use, if left unattended and before cleaning and storing.
• Location: Place the fan on a dry, flat, stable surface to avoid overturning.
• Keep clear: Ensure nothing is blocking the airflow outlet, air intake grilles or ventilation openings.
• Proper assembly: Do not operate the fan until fully assembled with all parts. Do not use the appliance without the protective grilles (rear and front guards). Do not attempt to force the grille in order to stop or start the fan.
• WARNING! DO NOT use the fan in the following areas:
  • Near an open flame, a hot burner, oven or other source of high heat.
  • On a soft surface (such as carpet) or where it may tip over during use.
  • Outdoors or in areas of high humidity.
  • In a bathroom, laundry area, near a sink, washer, pool or any source of water.
  • Near curtains or in tight corners, to enjoy maximum airflow.
  • In areas where paint, petrol, etc. is stored and there is a risk of explosion or fire from flammable gases, or in areas where substances are being sprayed.
• CAUTION! Personal safety: Avoid contact with moving parts. Never insert fingers, pencils or any other objects through the grilles when the fan is running, as this may cause electric shock and/or a fire hazard. Keep hair and loose clothing well away from the fan when it is in use.

Product Overview

Part Identification List

NOTE: Due to continued product improvement, images and illustrations in this manual may vary slightly from the product purchased. All images in this manual are for reference purposes only. Parts are not necessarily pictured to scale.

Getting Started

Before first use

• Unpacking: This product has been packaged to protect it against transportation damage. Unpack the appliance and keep the original packaging carton and materials in a safe place. It will help prevent any damage if the product needs to be transported in the future, and you can use it to store the appliance when it is not in use. In the event it is to be disposed of, please recycle all packaging materials where possible.
• Safe packaging disposal: Plastic wrapping can be a suffocation hazard for babies and young children, so ensure all packaging materials are out of their reach and disposed of safely.
• Inspection: Unwind the cord to its full length and inspect it for damage. Do not use the appliance if the appliance or its cord have been damaged or are not working properly. In case of damage, contact our after sales support centre for advice on examination, repair or return of the damaged product.
• Instructions: Make sure you have read and understood all instructions and warnings in this manual. Refer to the Product Overview, page 5, to familiarise yourself with the product and identify all parts. Pay particular attention to the safety instructions.
• Assembly: Your new fan has been shipped unassembled to minimise packaging waste. It is easy to disassemble for cleaning and storage. Assembly instructions are provided on the following pages. The instructions on page 7 and the illustrations on pages 8 and 9 show how all the parts fit together.

WARNING: Electric shock hazard! Do not connect the fan to power until it is fully assembled.

ASSEMBLY INSTRUCTIONS:

1. Unscrew the Plastic grille nut (anticlockwise) and remove. [refer Figure 1]
2. Place the Rear grille in the correct position with the handle located upwards. Screw on the Plastic grille nut tightly to attach Rear grille. [refer Figure 2]
3. Remove and discard the plastic protective packaging sleeve on the motor shaft.
4. Install the Fan blade onto the shaft until the retaining pin fits into the notch on the blade. Screw Blade cap to the motor shaft counter clockwise (tighten by turning to the left) [refer Figure 3]
5. Place the Guard centre cap onto the Front grille. [refer Figure 4]
6. Mount Front Safety Grille onto Rear Grille by hanging the top hook clip of the front grille over the top of the Rear Grille. Close the Locking clips all around the grille then fit and tighten the safety screw [refer Figure 5]
7. Install the Base onto the lower body, ensure the 4 screw holes align, fit the and tighten the fitting screws [refer Figure 6]

Instructions

Using the fan
Decide on a location for the fan: convenient to a mains electrical supply socket. Place the fan on a dry, level surface floor where it will not overturn during use. If moving the fan to a different location, switch off and unplug it from the mains. Make sure the fan is switched to the OFF [ 0 ] position, then insert the power plug into an appropriate electrical outlet and switch on power to the outlet.

Speed selection
To switch on the fan, select the appropriate speed setting (Fig.1) 1 = LOW; 2 = MEDIUM; 3 = HIGH; 0 = OFF.

Oscillation

• To set the fan into oscillation, press down the
  oscillation knob on top of the motor housing (Fig. 2). The fan head will pivot from one side to the other.

• For stationary operation, pull up the oscillation knob when the air is blowing in the desired direction.
  CAUTION: Do not reach across the front of the fan when operating the oscillation control to avoid the possibility of your clothing, sleeves, etc. entering and getting caught in the front guard.

Tilt adjustment
The fan head assembly can be tilted to direct the breeze upwards or downwards to your desired angle (Fig. 3).
Make sure the fan is unplugged from the power supply before adjusting the tilt angle.
CAUTION: Do not tilt back the fan head further than it is intended to go. Doing so will damage the unit.

Other Useful Information

WARNING!

• Before cleaning, maintenance or moving the fan, and before removing a front or rear grille, switch off the fan and unplug it from the wall outlet.
• Do not immerse the fan in water or other liquids. Do not spray it with liquids. Do not allow water to drip on or into the fan motor housing.
• Never use petrol, solvents, harsh detergents, or abrasive or alkaline cleaners on the fan.

Cleaning and maintenance

• Dusting: Clean your fan periodically by lightly running a vacuum cleaner nozzle (soft brush) over the front and rear grilles to remove any dust or dirt that may have accumulated inside or on the unit. Alternatively, use a soft, dry cloth for dusting.

• Stubborn stains: Use a slightly damp, soapy cloth for stubborn stains but be sure the cloth is not too wet. Use caution around the motor housing. Do not allow the motor or other electrical components to be exposed to water.

• Blade cleaning: If the blades need cleaning, first remove the front grille by loosening the fan grille securing clips along with securing screw (refer Product Specifications Page 5) (Fig.4). Wipe the blades clean using a damp cloth, dry thoroughly. Refit the front grille and ensure all the screws and washers are inserted and tightened properly.

• Storage: In the off season, store the clean and dry fan in a safe, dry location, protected from dust. We recommend using the original carton for storage of the disassembled product (follow the assembly instructions in reverse order to disassemble). Alternatively, place a large plastic bag or old towel over the top of the cleaned appliance for dust protection.

• Service/repair: The appliance requires no maintenance and contains no user-serviceable parts. Do not attempt to take the motor unit apart, repair or modify it. Do not operate the fan if its power cord or plug is damaged,or when it is working abnormally. In case of damage or malfunction, or if the cord is damaged, have the unit repaired by trained personnel only, or contact the after sales support line for advice on repair or replacement.

• Before phoning for a service, please ensure that your fan is properly assembled and all parts are undamaged and in good working order. Also ensure that the front and rear grilles are clean and free of obstructions and that the fan is properly connected to your power supply.

Technical specifications

Compliance
This appliance has been fully tested and meets all requirements as set out by standards AS/NZS 60335.1 and AS/NZS 60335.2.80.

The RCM Mark (Regulatory Compliance Mark) indicates that the product complies with the relevant guidelines of the ACMA as well as corresponding government requirements for the safety of electrical devices.

Responsible disposal

• At the end of its working life, make the appliance unserviceable by unplugging it from the power outlet and cutting the power cord.
• Do not throw this appliance out with your household rubbish. Electrical and electronic products contain substances which can have a detrimental effect on the environment and human health if disposed of inappropriately.Observe any local regulations regarding the disposal of electrical consumer goods and dispose of it appropriately for recycling. Contact your local authorities for advice on recycling facilities in your area.

Warranty

We pride ourselves on producing a range of quality home appliances that are both packed with features and completely reliable. We are so confident in our products, we back them up with a 1 year warranty. Now you too can relax knowing that you are covered. Customer Helpline NZ: 0800 422 274 This Product is covered by a 1 year warranty when accompanied by proof of purchase.
IM Version 2.0 – MAY 2019

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>