HTW VP-60FS Pedestal Fan User Manual

: June 1, 2024
: HTW

Table of Contents

HTW VP-60FS Pedestal Fan
Product Information
SAFETY PRECAUTIONS
ASSEMBLY INSTRUCTIONS
FUNCTIONS OF OPERATION PANEL
DISPOSAL
Contacts
Documents / Resources

HTW VP-60FS Pedestal Fan

HTW-VP-60FS-Pedestal-Fan-product

Product Information

Specifications

Model: HTW-VP-60FS
Type: Pedestal Fan
Features: Adjustable height, Timer function, Multiple speed settings

Frequently Asked Questions

Q: How do I adjust the speed settings of the pedestal fan?
- A: The speed settings can be adjusted using the speed indicator on the fan control panel. Select from high, medium, or low-speed options based on your preference.
Q: Can the pedestal fan be used outdoors?
- A: It is recommended to use the pedestal fan in indoor environments to prevent exposure to moisture or extreme weather conditions that may affect its performance.
Q: What should I do if the fan stops working suddenly?
- A: Check the power source, ensure the fan is plugged in properly, and inspect for any visible damage. If issues persist, contact customer support for further assistance.

Please, read carefully this manual before using the product

Thank you

SAFETY PRECAUTIONS

READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS FAN

Warning

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of electric shock from fire and injury to persons, including the following. Read all instructions before using the product:

The fan is only for intended use as described in this manual. All other uses not recommended in the manual may cause fire, electric shock, or injury to persons.
This fan is intended for home use only.
To protect against electric shock, do not immerse the fan, plug, or cord in water or spray them with liquids.
Close supervision is necessary when any appliance is used by or near children..
Always unplug the fan when not in use, when moving the fan from one location to another, and before cleaning.
Do not operate the fan with a damaged cord or plug or after the fan has malfunctioned or has been dropped or damaged in any manner.
The use of accessories not recommended by the manufacturer can be dangerous.
Do not use it outdoors.
Do not let the cord hang over the edge of a table or counter or touch any hot surface.
To disconnect, hold plug and pull from wall outlet. Never pull on the cord.
Do not operate without fan louver in place.
Always use on a dry, level surface.
If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person to avoid a hazard.
If the plug does not fit fully into the outlet, reverse the plug. If it still doesn’t fit, contact a qualified electrician.

INSTRUCTIONS FOR SAFE OPERATION

Do not operate in the presence of explosive or flammable gases.
Avoid contact with moving parts. Never insert fingers, pencils or other similar objects through the protector.
Do not place the fan or its parts near an open flame, stove or other heating appliances.
This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance.

CLEANING AND CARE INSTRUCTIONS

Always unplug the fan before cleaning, simply lift the ring clips on the guards and remove the front guard.
Use a soft cloth, moistened with a mild soap, to clean the fan and guard. Do not use abrasive cleaners.
Do not submerge the fan in water and never allow water to soak into the motor component.
Do not use gasoline, thinner or other chemicals to clean the fan.

ASSEMBLY INSTRUCTIONS

HTW-VP-60FS-Pedestal-Fan-fig-2

Front grill
Blade nut
Blade
Grill nut
Rear grill
Fan head
Decorative ring screw
Display panel
Fan body
Body Screw
Tube nut
Fan tube
Base
Spacer
L-shaped screw
Decorative ring
Grill Screw

STEPS:

Unscrew the L-shaped screw (15) from the fan tube (12), remove the spacer and screw.
Install the L-shaped screw with spacer through the hole of the base to connect the pipe, tighten the screw.
Place the base on a dry, level surface. Unscrew the tube nut (11); Pull out the inner tube to the top. (You may have to push up from below to lift it up.)
Install the tube nut and tighten it by turning it clockwise.
Place the fan body (9) on top of the inner tube, tighten the body screw.
Unscrew the grill nut (4) on the front of the motor by turning it counterclockwise.
Mount the rear grill (5) to the front engine cover by matching the 3 holes in the grill with the 3 round positioning knobs on the front engine cover. Push firmly until the 3 knobs protrude through the 3 holes.
Replace and tighten the grill nut (4) by turning it clockwise to hold the rear grill in place.
Place the fan blades (3) on the motor shaft matching the slots on the shafts with the slots on the blades, tighten the Blade to Blade nut (2) by turning it counterclockwise.
Test the fan by turning it with your hands, make sure there is no contact with the nut. The fan blade should rotate freely.
Use 3 screws to install the decorative ring in the middle of the front grill.
Unscrew the grill screw (17) from the front grill.
Mount the front grille (1) to the rear grille (5) by hanging the top hook clip of the front grille over the top of the rear grille. Close the clamps around the grill, finally put the nut on and screw through the hole in the bottom edge of the front grill and tighten.

FUNCTIONS OF OPERATION PANEL

OSCILLATION CONTROL

To make the fan oscillate, press down on the oscillation knob located on top of the motor housing. To stop the fan oscillating, pull up on the oscillation knob when the fan is in the desired position.

HTW-VP-60FS-Pedestal-Fan-fig-3

POWER/SPEED button
Off button
TURN BUTTON
Mode button
Timer button
Turn indicator
Timer indicator (0.5H, 1H, 2H, 4H)
Fan speed indicator (high, medium, low)
Mode indicator

FUNCTIONING

Place the fan on a dry, level surface.
Plug the power cord into a standard 220-240V AC wall outlet.
Press the “SPEED/ON” key to set the desired speed “HIG “MED” “LOW”.
Press the “OFF” key to turn off the fan.
Press “SWING” to start or stop the fan head swing.
Press the “MODE” key to switch from normal airflow to “SLEEP” MODE. In “SLEEP MODE”, ALL lights will turn off within 30 seconds, if there is no other operation here.

NOTES ON CLEANING THE FAN:

Always unplug the fan before cleaning, simply lift the clips on the guard ring and remove the front guard.
Use a soft cloth moistened with mild soap to clean the fan and guard. Do not use abrasive cleaners.
DO NOT immerse the fan in water and never allow water to enter the motor component.
DO NOT use gasoline, thinner or other chemicals to clean the fan.

STORAGE

For storage, disassemble and clean the fan carefully as instructed and store in its original box. You may leave the fan assembled and covered to protect it from dust. Store the fan in a cool, dry place.

DISPOSAL

DISPOSAL OF APPLIANCES AND BATTERIES

After the implementation of the European Directive 2002/96/EU in the national legal system, the following applies:

Electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of tilizing old devices, you are making an important contribution to protecting our environment.

Contacts

GIA GROUP

C. Can Cabanyes, 88 08403 Granollers (Barcelona) – España
tel. +34 93 390 42 20
info@htwspain.com
www.htwspain.com

España: info@htwspain.com
Portugal: info@htw.pt
Italy: info.it@htwspain.com

SAT

España sat@groupgia.com
tel. +34 933904220
Portugal sat.pt@groupgia.com
Italy sat.it@groupgia.com
tel. +39 05641715509

Scan

HTW-VP-60FS-Pedestal-Fan-fig-5

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC

At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority-differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

+ info

HTW-VP-60FS-Pedestal-Fan-fig-1