BEGA 45 486.2 Pendant Luminaire Instruction Manual
- June 1, 2024
- BEGA
Table of Contents
BEGA 45 486.2 Pendant Luminaire
Pendant Luminaire For Indoor Use
Dimensions
Instructions For Use
Application
Pendant luminaire · indoor luminaire for free radiating and uniform light with
hand-blown opal glass, satin matt and metal housing.
Lamp
Luminaire with screw base E 27 Lamp output max. 75 W This product contains
light sources of energy efficiency class E.
Supplied lamp BEGA LED lamp 13565 LED 12 W · 1400 l m · 2700 K dimmable.
Supplied lamp BEGA LED lamp 13592 LED 12 W · 1520 l m · 3000 K dimmable.
Luminaire efficiency: 86%
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Product description
Stainless steel fitter and canopy
Hand-blown opal glass, satin matt
Black flex suspension 3 × 0,75
with 1 steel messenger wire
Overall length of luminaire approx. 2000mm
Connection terminal 2.5
Earth conductor connection
Lamp holder E 27
Safety class I
– Conformity mark
Weight: 1.5 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Installation
Suspend the luminaire from the ceiling hook. Make earth connection and
electrical connection to the terminals. Insert lamp into lamp holder. Unscrew
glass cover and lift it. Place glass onto the glass support and adjust it
accordingly. Screw glass cover onto the glass. Press canopy against the
ceiling. The clamping effect for different cable diameters can be adjusted by
the knurled nut at the lower part of the canopy.
Shortening of flex suspension
The flex suspension can only be shortened at the canopy end. Remove terminals
from the cable. Loosen fixing screw at the hanger, pull out the steel wire and
loosen screws from the cable collar. Shorten cable to the desired length and
strip end approx. 10 cm. Please consider these when cutting the cable to the
required length. Place cable back into the cable collar and tighten both
screws. Make sure that approx. 5 mm off the cable coating protrude out off the
collar. Lead the steel wire through the little hole in the hanger and lead it
back through the fixing terminal. Pull steel wire tight and fix it with screw.
Connect wires to the terminals and make sure to connect the steel wire to the
earth terminal.
Re lamping · Maintenance
Disconnect the electrical installation. To clean the luminaire and to change
the lamp unscrew glass cover and lift it. Take off the glass. Clean glass and
luminaire. Use only solvent-free cleansers. Change the lamp.
Spares
Spare glass 11 002 231 .0RG
LED lamp 2700 K 13 565
LED lamp 3000 K 13 592
Lamp holder 63 000 339
Cover cap 71 001 575 .1L
Canopy 71 001 636 .1M2
Customer Support
2/2 BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>