COLLINGWOOD JB2 Wiring Series Instructions
- June 4, 2024
- COLLINGWOOD
Table of Contents
COLLINGWOOD JB2 Wiring Series
SERIES WIRING
Instructions
JB2 (IP68 to 2 meters)
LED unit
Detailed wiring
instructions are supplied with JB2 and JB4
JB4 (IP68 to 1.3 metres)
Cut-out
LED UNITS IN DAMP/WET ENVIRONMENTS
A suitable waterproof junction box or enclosure must be used to maintain the
IP rating of the product.
Failure to use a suitable junction box or enclosure will invalidate the
warranty Collingwood Lighting recommend junction box JB2 or JB4 (examples
above show 5x LED units wired in series)
WARNING: Do not install LED units into wood which has been treated with
creosote, e.g. Old railway sleepers. Creosote fumes can permeate the silicone
seals and damage the LEDs.
See overleaf for wiring in a damp/wet environment
LED UNITS IN DRY ENVIRONMENT (i.e. no moisture or condensation)
Junction boxes JB2 or JB4 (see overleaf) may be used for convenience.
Alternatively, wire the LED units in series to the LED driver using any connectors suitable for SELV (Separated Extra Low Voltage)
- Connect red wire of first LED unit to + (plus) driver output terminal.
- Connect black wire of last LED unit to – (minus) driver output terminal.
- Connect black to red as shown, i.e. current flows ‘in’ through each red wire and ‘out’ through each black wire.
- The diagram above is an example with three LED units wired in series.
- WARNING: Do not install LED units into wood which has been treated with creosote, e.g. old railway sleepers. Creosote fumes can permeate the silicone seals and damage the LEDs.
t +44 (0) 1604 495 151 f +44 (0) 1604 495 095
email sales@collingwoodgroup.com
website collingwoodlighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>