QualGear QG-PRO-PM-SCA2-W Suspended Ceiling Adapter Instruction Manual

QualGear QG-PRO-PM-SCA2-W Suspended Ceiling Adapter Instruction Manual

Please read the entire installation manual before you start installation and assembly.

⚠ WARNING

• Do not begin to install your QualGear product until you have read and understood all the instructions and warnings contained in this installation manual. If you have any questions regarding the instructions, for US customers please contact QualGear customer support via email at support@qualgear.com. For all international customers, please contact your local district bu tor.

• This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.

• This product was designed to be installed and utilized only as specified in this manual.
  Improper installation of this product may cause damage or serious injury. QualGear is not liable for the improper use or installation of its products.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

• Always use an assistant or mechanical lifting equipment to safely lift and position the equipment.

• Tighten screws firmly, but do not over tighten. Over tightening can damage the items, greatly reducing their holding power.

• ALL QUALGEAR products are intended for indoor use only and any outdoor use voids the limited warranty. For warranty information, please visit: http://www.qualgear.com/warranty.php

• Never exceed the maximum rated weight specified in this manual.

• All hardware must be used at the designated points in the installation instructions to prevent property damage and/or personal injury.

• This product was designed to be compatible with all standard 1.5″ NPT pipes.

IMPORTANT: Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.

Maintenance

Please check that the ceiling adapter is secure and safe to use at regular intervals. If you have any questions regarding any of the instructions or warnings, please contact your local distributor (OR) contact QualGear technical support via email at support@qualgear.com.

Parts Checklist

IMPORTANT: Before starting installation, please check that all parts shown in this checklist are included. If any parts are missing or damaged, contact your local distributor or support@qualgear.com for replacement parts and do not start assembly and installation until you receive all the parts.

Hardware Package

Mounting to a Wooden Joist or Wooden Stud Ceiling

Mark the drill locations on the center of the studs for security.

Mounting to a Concrete Ceiling

Mounting to a Truss

Loop wire around the truss and twist around itself several times to secure.

Attaching the joined ceiling plates to the ceiling

Attach the suspended wire from previous step to the turnbuckles (E), then hook the turnbuckles onto the joined ceiling plates (or ceiling tray) and make adjustment until the ceiling tray is levelled.

⚠ WARNING

• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.

Attaching the 1.5″ NPT Pipe to the Suspended Ceiling Adapter

To connect the 1.5″ NPT pipe (sold separately) to the ceiling adapter, twist the male threaded end into the female thread of the adapter. Then secure the position with screws (F or G) using the allen key (I).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>