Teufel Ultima 40 MK3 Stereo Column Speakers User Manual
- June 4, 2024
- Teufel
Table of Contents
Teufel Ultima 40 MK3 Stereo Column Speakers
General Notes and Information
Notice
The information in this document may change without prior notice and in no way
constitutes any liability on the part of Lautsprecher Teufel GmbH.
No part of this user manual may
be reproduced in any form or be broadcasted in any way electronically,
mechanically, by photocopy or recording without the written permis-sion of
Lautsprecher Teufel GmbH.
© Lautsprecher Teufel GmbH Version 4.0, March 2022
Original packaging
If you wish to exercise your right of return, we ask that you be absolutely
sure to hold on to the packaging. We can only accept the return of the
speakers WITH THE ORIGINAL PACK-AGING.
Empty boxes are not available!
Complaints
In case of a complaint we will need the following information to process your
enquiry:
For Your Safety
Proper use
The speakers are designed for the playback of audio signals that are
transmitted by an external amplifier via a speaker cable.
Only use the speakers as described in this user manual. Any other use will be
deemed as not in accordance with the instructions and may lead to damage of
property or even persons.
The manufacturer accepts no liability for damage caused by improper use.
The speakers are intended for domestic use.
Explanation of terms
You will encounter the following signal terms in this user manual:
WARNING
-
This signal term indicates a moderate risk, which, if not avoided, may result in death or severe injury.
CAUTION -
This signal term indicates a low risk, which, if not avoided, may result in minor or moderate injury.
NOTICE -
This signal term warns you of potential damage.
Safety notes
This chapter contains general safety notes which you should always observe to
protect yourself and third parties. Also observe the warning notes in each
chapter of this user manual.
An unsuitable setup location may result in injury and damage.
-
If the speakers are not securely mounted, do not use them in vehicles, in unstable locations, on wobbly tripods or furniture, on underdimensioned brackets etc. The speakers may tip or fall over and cause injury to persons or be damaged themselves.
-
Place the speakers on the ground only.
-
Place the speakers in such a way that they cannot be knocked over inadvertently and make sure that the cables do not pose a tripping hazard.
-
Do not place the speakers near heat sources (e.g. heaters, ovens, other heat generating equipment such as amplifiers etc.).
Children can become trapped in the plastic wrapping when playing and suffocate. -
Do not allow children to play with the device or the plastic wrapping. There is a danger of suffocation.
-
Ensure that children do not remove small parts from the unit or take them off of the unit (e.g. control knobs or plug adapters). They could swallow the parts and choke.
Extended listening at high volumes may lead to hearing loss.
To avoid damage to health, avoid extended listening at high volumes. -
When the volume is set high, always keep a certain distance and never hold your ears directly on the speaker.
-
If an amplifier is set to full volume, this may produce very high sound pressure. This may have psycho-logical consequences and also cause physical injury. Children and pets are particularly at risk. Set the volume control of your amplifier to a low setting before you turn it on.
This product contains magnetic material. -
If necessary, consult your physician and ask for effects on implants such as pacemakers or defibrilla-tors.
If the speakers are subjected to warm temperatures after being cold – (e.g. after transport), condensation may occur inside of them. -
In this case, wait at least 2 hours before you connect and activate the speakers.
Improper handling of the speakers may result in damage or fire. -
Do not place open flames such as burning candles or similar on the speakers.
-
Ensure sufficient ventilation.
-
Do not expose the speakers to direct sunlight.
-
Only use the speakers in indoor areas.
-
Do not use the speakers in wet rooms and protect them against dripping or spraying water. Make sure that no vases or other liquid-filled objects are located on or near the speakers in order to prevent liquid from penetrating the housing.
If the amplifier is undertaken-sioned, the amplifier may end up in clipping operation at high volumes, which could destroy the tweeters. -
Only connect your speakers to amplifiers, which suit the output of your speakers.
An over-dimensioned amplifier can destroy the bass speakers due to excessive volume. -
If the music playback sounds distorted, reduce the volume.
Unpacking and Setup
Unpacking
Carefully open the boxes, take out the EPE foam parts and carefully lift the
speakers out of the box without touching the diaphragms.
Due to diverse different customer requirements, the Ultima 40 series is
shipped without any speaker cables. You can find suitable cables in our
webshop (www.teufelaudio.com) in the
“Accessories” area.
NOTICE
Check that all items have been delivered and that nothing is damaged. If
you find any damage, do not operate the device; instead contact our customer
service department.
Location tips
- Select a stable, level base.
- Make sure that the environment is clean and free from dust.
- Select a location away from heat sources and direct sunlight.
- Lay the connector cords so that they do not pose a tripping hazard.
- Do not place any heavy objects on the cables or the speakers.
Positioning the speakers
The following data concern an “ideal listening room”, in which the listener
sits in a central position at a sufficient distance in front of the speakers
(see the graphic) and no objects (tables or the like) are located in between.
Unfortunately, the room, furnishings or other circumstances do not always
allow for optimum arrangement.
Modern amplifiers offer a variety of possibilities for electronically
compensating losses associated with the arrangement. The following general
rule applies: You can always experiment on what works best in your listening
room in terms of sound and appearance based on our recommendations. Let your
ears (and eyes) decide!
The speakers should be situated to the left and right of the listener and if possible, form an equilateral triangle with the listener – the so-called stereo triangle (distance from the listener = distance between the speakers). The speakers should project sound straight into the room or be arranged slightly towards the listener.
Removing the protective grids
You can take the protective grids off of the speakers by carefully reaching
behind the protective grids and slowly pulling them off to the front.
By removing the protective grid, especially high frequencies will sound
clearer.
When putting the protective grids on, please make sure that the installation
pins slide directly into the corresponding jacks on the speaker.
Connecting
Connection variations
On the back of the speakers is a connection terminal with four clamps. Here
you can connect the speaker cables directly or using pin plugs. Only the
direct connection is described here.
The terminals are marked in red (+) and black (-).
In addition to the normal connection where each speaker column is connected to
the amplifier with a cable, you can also select the variations “bi-wiring” or
“bi-amping”.
Normal connection
With this method, the ULTIMA 40 MK3 speakers are connected like conventional
speakers with one 2-strand speaker cable each. The contact bridges between the
connector terminals must not be removed; you can connect the speaker cables
accordingly to the top or bottom terminals.
Bi-wiring
In the process, the high and mid-range speakers with a speaker cable and the
two low tone speakers with a second speaker cable are connected.
Bi-amping
Here, the high/mid-range and low-range speakers are each supplied with their
own power amplifiers.
You must remove the contact bridges for bi-wiring or bi-amping operation only:
To do this, loosen the connector terminals by turning them anticlockwise and
pull the contact bridges out. The upper terminals lead to the high and mid-
range speakers and the bottom terminals lead to the low-range speakers.
Connecting the cables
CAUTION
Risk of tripping! – Lay the cables so that they do not pose a tripping hazard.
-
Turn your amplifier off.
-
Lay the speaker cable from your amplifier to each speaker. Use a high-quality double wire speaker cable with marked strands for this. The cable should have a diameter of at least 1.5 mm2.
NOTICE
Make sure the polarity is correct! – Connect each of the like-colored terminals of your speakers and your amplifier with one another; otherwise the sound quality will suffer. To facilitate this, the individual single wires of the speaker cables are marked with different colors or shapes. -
Split the single wire down by approx. 30 mm on both ends and remove approx. 10 mm of insulation each. Twist the stripped wire ends so that no strands are protruding.
-
Turn the connector terminals anticlockwise until loose. Insert the stripped ends of the single wires in the holes that are now visible. Close the terminals by turning them clockwise.
The speaker cable has now been clamped in place. -
Connect the other end of the speaker cables to your amplifier. You should be able to find corresponding notes in the user
manual of your device.
Care and Cleaning
The veneered surfaces of our speakers have a protective surface coat so they no wood polish is necessary.
NOTICE
External influences may damage or destroy the device.
- If possible, only use plain water without any additives. In case of stubborn marks, a mild soap solution may be used.
- Do not use caustic cleaning products, white spirit, thinners, petrol or similar under any circumstances. Such cleaning agents may damage the delicate surface of the housing.
- Ideally, you should remove dust or small amounts of dirt with a dry, smooth leather cloth.
- Rub off stubborn dirt with a damp cloth. Make sure that no liquid penetrates the speakers.
- Then immediately wipe the surfaces dry with a soft cloth without applying pressure.
Technical Data
- Impedance: 4–8 Ohm
- Sinus power: 120 Watt (longterm), 200 Watt (shortterm)
- Recommended cross-over
- frequency when using a subwoofer: 40 Hz
- X-over frequencies: 540 Hz, 2900 Hz
- Woofer: 165 mm
- Mid-range speaker: 165 mm
- High-range speaker: 25.4 mm
- Volume: 52 Liter
- Dimensions (W × D × H): 215 mm × 352 mm × 1060 mm
- Net weight: 20.3 kg
You can find further technical data on our website. Technical changes reserved!
Declaration of Conformity
Lautsprecher Teufel GmbH declares that this product complies with the relevant
European and national directives. The full text of the CE Declaration of
Conformity can be found at this web address:
www.teufel.de/konformitaetserklaerungen
www.teufelaudio.com/declaration-of-conformity
Disposal
Important information in accordance with the Electrical and Electronic
Equipment Act (Germany: ElektroG)
We advise owners of electrical and electronic appliances that old electrical
and electronic devices must be handed in separately from municipal waste, in
accordance with the applicable regulations. Batteries and rechargeable
batteries that are not firmly enclosed in old electrical devices and lamps,
and that can be removed from the old device without destroying them, must be
separated from them in a non-destructive manner before they are handed to the
collection point for their intended disposal. Please take note of our
information on the Batteries Act
[Germany: BattG] below for disposing of batteries. You make an important
contribution to returning, recycling and further processing of old devices if
you separate your old devices into the correct collection groups for
recycling. The symbol below of a crossed-out dustbin, applied to electrical
and electronic appliances, also advises of the duty to separate collections:
Consumer electronics stores and supermarkets are obliged, under certain
conditions, to take back old electrical and electronic devices, in accordance
with section 17 of the Electrical and Electronic Equipment Act. Stationary
retailers must take back an old electrical device of the same type when a new
electrical device is bought (1:1 return). This also applies to home
deliveries. These retailers must also take back up to three small old
electrical devices (≤ 25cm) without this being linked to a new purchase (0:1
return).
In accordance with the Electrical and Electronic Equipment Act, as online
retailers of electrical devices and due to our product range, our obligation
is limited to 1:1 return of large devices of > 50 cm when selling a new
electrical or electronic device of the same type. We comply with the
obligation of return of devices other than large devices through our service
provider. You can find the exact contact data and collection points on our
website www.Teufel.de/entsorgung. It is
also possible to return old electrical and electronic appliances free of
charge at an official delivery point run by the public waste disposal
authorities.
Important: For safety reasons we ask that you refrain from sending lighting
fixtures (some lamps). For return of lighting fixtures please use the public
waste disposal collection points or contact us directly at
www.Teufel.de/entsorgung. As an end-user,
you are responsible for deleting any personal data on old electrical
appliances before handing it in.
Important: Our appliances can contain batteries/rechargeable batteries. If
this is the case, please refer to its attached product documentation for
additional information on the type and chemical make-up of the battery. For
products with battery compartments, you can directly remove the batteries or
rechargeable batteries and dispose of them properly. If the batteries are
built into the product, do not in any case attempt to remove the batteries
yourself, instead contact one of our employees or appropriate specialist
staff.
Please contact our customer service department with any questions, suggestions, or complaints:
Phone: 00800 200 300 40 (toll-free)
Fax: +49 (0)30 – 300 930 930
Online-support:
www.teufelaudio.com/service
Contact:
www.teufelaudio.com/contact
References
- Entsorgung | Teufel
- Konformitätserklärungen | Teufel
- Teufel: Speakers & Headphones Direct from the Manufacturer Online
- Declaration of conformity | Teufel
- Support | Teufel
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>