anslut 016711 Battery-Powered Led Christmas Tree Lights Instruction Manual

June 4, 2024
anslut

anslut 016711 Battery-Powered Led Christmas Tree Lights

Care for the environment!
Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority’s recycling station. Jula reserves the right to make changes. In the event of problems, please contact our customer service. www.jula.com

SAFETY INSTRUCTIONS

Read these instructions carefully before use, and save them for future reference. These instructions should be enclosed with the product if it is sold or passed on.

  • This product can be used by children from 8 years of age and by persons with physical, sensorial or mental disabilities, or persons who lack experience or knowledge, if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved.
  • Keep children under supervision to make sure they do not play with the product. Do not allow children to clean or maintain the product without supervision.
  • The product is only intended for indoor use.
  • Clean the outside of the product with a damp cloth.
  • The LEDs in the lights cannot be replaced. The complete light must therefore be discarded if there is a fault on an LED.

BATTERIES

  • Only use 1.5 V batteries, size AAA.
  • Do not attempt to charge non-rechargeable batteries. Risk of explosion.
  • Remove discharged batteries from the product at once, otherwise, there is a risk of battery leakage.
  • Store batteries out of the reach of children and pets. Never short circuit, dismantle or burn batteries.
  • Seek medical attention immediately if anyone has swallowed a battery.
  • Check and if necessary clean the battery contact surfaces on the product before inserting the batteries.
  • Insert the batteries with the correct polarity.
  • Remove the batteries if the product is not going to be used for some time.
  • Do not expose batteries to direct sunlight, naked flames, high temperatures or other extreme conditions, and do not put them on radiators.
  • Avoid getting battery fluid on the skin, in the eyes or on the mucous membranes. On contact with battery fluid, rinse immediately with plenty of water and seek medical attention.
  • Check that the product is switched off after use.

SYMBOLS

  • Read the instructions.
  • Safety class III.
  • Approved in accordance with the relevant directives.
  • Recycle end-of-life products in accordance with local regulations.

TECHNICAL DATA

USE

BEFORE USE

  1. The lights are fastened on the branches of the tree with clips in the base.
  2. Check that the lights are firmly in place.
  3. Make sure there are no obstructions between the remote control and the lights. The range of the remote control will be reduced if the charge level of
    the batteries is low, or if there are obstructions between the remote control and the lights.

HOW TO USE

The lights are switched on with the buttons on the remote control, either with constant warm white or amber, or with alternating colour (RGB). The brightness can be set with the + and – buttons for the constant colors warm white and amber. Press the OFF button to switch off the lights. An irregular brightness that resembles flickering flames can be set for the constant colors warm white and amber – push the button for warm white until the light begins to “flicker”.

  1. Unscrew the light from its base (anticlockwise) and remove the discharged battery.
  2. Insert a 1.5 V battery AAA with the positive terminal pointing forwards in the direction of insertion.
  3. Carefully screw the light back on its base. Do not overtighten, this can damage the thread. The light goes on when it is screwed together if the battery is correctly inserted.

Remote control (transmitter)

NOTE

Always replace both batteries at the same time. Do not mix new and old batteries or different types of batteries.

  1. Push the battery cover on the back of the remote control in the direction of the arrow and remove it. Remove the discharged batteries.
  2. Insert two 1.5 V batteries AAA with the correct polarity as shown by the markings (+/–) in the battery compartment.
  3. Replace the battery cover.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals