SEALEY LED2500SB LED Super Beam Rechargeable Pocket Light Instruction Manual

24W SMD LED SUPER BEAM RECHARGEABLE
POCKET LIGHT, 2500LM, 4 LIGHT MODES
MODEL NO: LED2500SB

LED2500SB LED Super Beam Rechargeable Pocket Light

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Refer to instructions

SAFETY

✔ Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use.
✔ Ensure the light is fully charged before initial use.
DO NOT charge in damp conditions.
DO NOT turn the light on when it is being charged.
DO NOT shine directly into you’re, another person’s or an animal’s eyes.
DO NOT allow children to use the light.
DO NOT handle or move the light whilst it is being charged.
DO NOT use the light if you suspect that the battery or the light casing is damaged.
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.
DO NOT attempt to open, disassemble, modify or service the battery pack.
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
DO NOT expose to temperatures above 60°C (140°).
✔ Replace only with the battery pack designated for this product.
✔  Recycle or dispose of used battery as stipulated by local regulation.
✔ If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

INTRODUCTION

Powerful 24W torch with 2500lm output. Four modes of light; low, medium, high and super beam mode. Lightweight aluminium housing.
Convenient small pocket size for easy transportation. Intelligent LED charging indicator. Rechargeable battery with 2hr charge time (supplied with 500mm USB-C charging cable). Includes strong magnet on the base to aid hands free use. IP rating: IP44.

SPECIFICATION

The battery fitted to this light is considered to be a consumable item and its ability to accept a charge will reduce over time. We will provide warranty against mechanical and electrical defect for a period of one year – this does not cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the battery regardless of whether it is less than one year old.
Note: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another charge.

OPERATION

4.1. Connect the USB lead to the socket on the side of the light. See fig.1.
Connect the other end into a charging socket. Turn on power supply.
The ON/OFF button will flash to indicate charging. Once light has been charged the ON/OFF button stops flashing.
4.2. The charging time to fully charge takes 2hrs. The ON/OFF button will flash when the light requires charging.
WARNING! Never direct light into eyes.
4.3. To operate the light press ON/OFF button. The button illuminates to confirm operation. See fig.2. To select the brightness level press the ON/OFF button until desired brightness. There are four brightness settings and a super beam to choose from.
4.4. To use the super beam function, hold the power button down, the light will illuminate up to 2500lms for 30 seconds.
4.5. To switch the light off press the ON/OFF button until the light turns off. BATTERY REMOVAL
Unscrew the base of the light. Remove the battery. Dispose of according to local government guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

https://qrco.de/bcy2E9

WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No Liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
 01284 757500
 sales@sealey.co.uk
 www.sealey.co.uk
Original Language Version
© Jack Sealey Limited
1500SLR Issue 4 (2) 07/12/23

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>