eurowise 958 Cayenne Rock Slider Instruction Manual
- May 15, 2024
- eurowise
Table of Contents
eurowise 958 Cayenne Rock Slider
Product Information
Specifications
- Product Name: Rock Slider
- Compatible Models: 958 Cayenne, T3 Touareg (Air suspension / Steel spring)
- Model Year: Gen 2 2010+
- Manufacturer: Eurowise
Product Usage Instructions
- Remove left and right lower plastic under shield by unscrewing the torx screws.
- Discard the hardware and covers that were holding the shields in place.
Contact Information
- If you have any questions, comments, or concerns related to your product, please contact us at:
- 440 Springbrook Road, Charlotte, NC 28217 | Phone: 704-559-8100
- Email: [email protected]
- Website: www.eurowise.com
- Shop: shop.eurowise.com
FAQ
-
Are the installation steps the same for both air suspension and steel spring models?
Yes, the installation steps are the same for all models, but some components shown in the photos may not be relevant to steel spring models. -
Do I need any special tools for the installation?
You will need a torx screwdriver to remove the lower plastic under shields.
INSTALLATION INSTRUCTION
This installation is a guide to help install your Gen 2 2010+ cayenne /
Touareg Rock sliders.
Photos below may differ from your T3 / 958 underbody plastics. The vehicle in
these photos are for a air suspension 958. IF you have a steel spring chassis
than some of the items in the photos will not pertain to you. Overall its the
same processes on all models.
- remove left and right lower plastic under shield. these are held on with torx screws. You will no longer need the hardware or covers.
-
with the covers removed you will see all the body plugs that will need to be removed in order to install the rock sliders. They are just snapped in so you can pop out by hand or with a flat head. there is 6 total, the other 2 arrows point to the mounting points that are already threaded in the body, and the other 2 smaller blind holes are for the smaller locking hardware.
So 12 mounting points total. -
This is what the mounting hardware looks like. The larger bolt of the two go vertical in the side of the body ( QTY 3 per side ) and the last two go inside the lower frame rail parallel with the car. They will have plastic holding sleeves threaded onto them. dont remove these. they will make your life easier when it comes to installing them. We have paper in these photos but you will have plastic in place. slip the large end into the blind hole and then feed the opposite end in so the bolt now is flush. when installing the rock sliders the bolt sandwiches between the rock slider on the frame for a secure mounting finish.
The next photos below show how the Special L bolts we included are installed in the frame rails. ( photos may not reflect your car.
The hardware kit is assembled is built for multiple applications so you may have leftover hardware. Nothing to be alarmed about.
IF YOU HAVE ANY QUESTIONS, COMMENTS, OR CONCERNS RELATED TO YOUR PRODUCT
PLEASE CONTACT US!
ABOUT COMPANY
- 440 SPRINGBROOK ROAD. CHARLOTTE, NC 28217
- 704-559-8100
- [email protected]
- WWW.EUROWISE.COM
- SHOP.EUROWISE.COM
References
- Specializing in European Service, Performance and Fabrication – Eurowise Performance
- Eurowise Audi, BMW, Volkswagen, Mercedes, & Porsche Service