W463 Eurowise Wagon Radius Arm Instruction Manual

Eurowise Gwagen / w463 radius arm
installation

INSTALLATION INSTRUCTIONS

–PROFESSIONAL INSTALLATION HIGHLY SUGGESTED AND ADDITIONAL HELP–

TOOLS REQUIRED:
24MM 6 POINT SOCKET
24MM OPEN ENDED WRENCH
16MM SOCKET & WRENCH
17MM SOCKET & WRENCH
LARGE PRY BAR
HAMMER

• Always allow car to cool before performing any installation(s) or service(s) on it.

• Always be sure to work on an even and level surface when raising vehicle(s) with a jack, and
  support all raised vehicles with locked jack stands once elevated.

• Eurowise recommends that all installations be supervised or verified by a trained professional technician.

• Eurowise is not responsible for any personal injury or damage(s) sustained to a vehicle during installation of aftermarket performance parts. If you have any questions, comments, or concerns.
  related to your product, please contact us!

CAUTION

440 Springbrook road. charlotte, nc 28217 | 704-559-8100
info@eurowise.com | www.eurowiSe.com | Shop.EuroWiSe.com

INSTALL TIP

When installing the tie rod that is removed to install the radius arm. With one side completely installed and the opposite side loose, install the tie rod link fully and then drop the radius arm down into place. The tie rod cannot be installed after the radius arm is completely bolted in on both sides.

1. Jack up vehicle until the wheels are barely off the ground. Wheels do not need to be removed.
   Having wheels still on the car while working on the ground keeps the axle from falling down.

2. Remove sway bar bolts on both sides and drop sway bar down ( 16mm nuts ) you do not need to completely remove.

3. Disconnect the headlight level arm ( if equipped ) from drivers arm.

4. Remove cotter pins and castle nuts on each tie rod on both sides ( 24mm ) This is the bar on. the backside of the axle. Remove the bar completely.

5. Unbolt both 24mm nuts from either driver or passenger side axle holding radius arm on.

6. Unbolt rear 24mm rear single nut holding the shaft onto the chassis.

7. Using pry bar remove the radius arm from front of the axle and then pull arm out towards front of the vehicle.

8. Install new Radius arm before removing other OEM Radius arm.

9. Remove opposite OEM Radius arm and install new arm but do not install completely.

10. Install tie rod back on completely.

11. Now finish bolting the New radius arm into place.

12. Install sway bar back onto the new radius arms.

13. Professionally align the vehicle.

IF YOU HAVE ANY QUESTIONS, COMMENTS, OR CONCERNS RELATED TO YOUR PRODUCT,PLEASE CONTACT US!
Eurowise-Control-Arm-Installation-Manual.pdf

https://qr.page/g/3U4jPKqCrIF

440 SPRINGBROOK ROAD.
CHARLOTTE, NC 28217
704-559-8100
INFO@EUROWISE.COM
WWW.EUROWISE.COM 
SHOP.EUROWISE.COM

References

• Specializing in European Service, Performance and Fabrication – Eurowise Performance
• Eurowise Audi, BMW, Volkswagen, Mercedes, & Porsche Service
• eurowise – Profile – Eurowise Forum

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>