NUX Reissue Series Recto Distortion Guitar Effect Pedal Owner’s Manual
- June 4, 2024
- NUX
Table of Contents
NUX Reissue Series Recto Distortion Guitar Effect Pedal
The NUX REC TO DISTORTION pedal from the Reissue Series has a heavy distortion sound with a tight bass response. It utilizes a pure analog circuit to simulate that typical famous American pre-amp high gain tone from the 90s’!
Overview
- Heavy Distortion Effect for Hard Rock and Metal.
- The extra amount of gain boost the higher frequency for a more “in-your-face” Distortion Effect.
- Bass and High Passive EQ.
- True-bypass Hardware Switching.
Specifications
- Input impedance: 1 M Ohms
- Output impedance: 1 OK Ohms
- Power: 9V battery or external AC adaptor delivering 9V DC regulated minimum 300mA
- Dimensions: 121 (L) X 77(Jv) X 48(D) mm
- Weight: 230g
- Do not place near heat sources, such as radiators, heat registers, or appliances that produce heat.
- Guard against objects or liquids entering the enclosure.
- Refer all servicing to qualified service personnel.
- Prolonged listening at high volume levels may cause irreparable hearing loss and/or damage. Always be sure to practice “safe listening”.
Follow all instructions and heed all warnings KEEP THESE INSTRUCTIONS!
Product Interface
-
POWER Jack
Use a regulated 9V DC adapter with Negative Tip to power this pedal. It’s highly recommended using the optional NUX ACD-006 Adaptor. Using an incompatible adaptor may cause noise or malfunction. -
BASS Knob
Sets the amount of low frequency. -
GAIN Knob
Sets the preamp gain. Turning it up will increase the distortion amount. -
TREBLE Knob
Sets the amount of high frequency. -
MASTER Knob
Controls the output volume of this pedal. -
OUTPUT Jack
Connect an amplifier to this jack. -
INPUT Jack
Connect your guitar to this jack. Plugging in this jack switches on the power whether the effect is engaged or bypassed. When not using this pedal, disconnect the cable from this jack to save battery life. -
ON/OFF Switch
Turns On/Off the effect.
Installing The Battery
A battery is supplied with the unit. Connect the snap cord to the battery and insert the battery as shown in the drawing. When the battery runs down the sound will change. In such case please replace it with a new battery. The power comes on when you insert the plug into the INPUT jack. The use of an AC adaptor is recommended as the unit’s power consumption is relatively high.
Accessories
- 9V battery
- Owner’s manual
- Warranty card
specifications and features are subject to change without notice.
WARNING!
IMPORTANT SAFETY INSTRUCTIONS BEFORE CONNECTING, READ INSTRUCTIONS
WARNING:
To reduce the risk of fire or electric shock, do not expose this appliance to
rain or moisture.
- The lightning symbol within a triangle means “electrical caution!” It indicates the presence of information about operating voltage and potential risks of electrical shock.
CAUTION:
To reduce the risk of fire or electric shock, do not remove screws. No user-
serviceable parts inside. Refer servicing to qualified service personnel.
- The exclamation point within a triangle means “caution!” Please read the information next to all caution signs.
CE mark for European Harmonized Standards
CE Mark which is attached to our company’s products of Battery mains the
product is in full conformity with the harmonized standard(s) EN
61000-6-3:2007+A1:201 t & EN 61000-6-1:2007 Under the Council Directive
2004/108/EC on Electromagnetic Compatibility.
www.nuxefx.com. Made in China.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>