eurowise Gen 1 Gas Tank Skid Instruction Manual

May 15, 2024
eurowise

eurowise Gen 1 Gas Tank Skid

eurowise Gen 1 Gas Tank Skid

INSTALLATION INSTRUCTION

Gen 1 / 2 gas tank skid install.

Each kit comes with nutserts to install in the rear subframe qty 1 on each side. The rear tab on gas tank skid attaches to this nutserts. ( please use proper m12 nutserts installation tool ).

Using custom L bolt these are installed in the frame. Be sure to install supplied plastic washer on the end of the stud. this keeps the Bolt from falling into the frame.

Other two mounting points you will remove the OEM 13mm bolt holding the gas tank up and the Eurowise gas tank skid will mount to these points. DO not worry removing the oem bolts will not drop the tank. just remove the only two needed at a time.

GEN 2 GAS TANK SKID BRACKETS

USE QTY 4 SUPPLIED CARRIAGE BOLTS AND NUTS TO ATTACH BRACKETS TO GAS TANK SKIDS

Installation Instruction

GEN 1 GAS TANK SKID BRACKETS

USE QTY 4 SUPPLIED CARRIAGE BOLTS AND NUTS TO ATTACH BRACKETS TO GAS TANK SKIDS

Installation Instruction

The gas tank skids can be installed with the OEM plastics on but you will need to trim around the plastic to clear accordingly.

Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction

These photos below are the t3 / cayenne gas tank skids ( 2010-2017 ).

They have removable inner mounting brackets. these will be installed at any time. You install the carriage bolts supplied facing inwards. You can install them before putting the skids up or after.

The rest of the install is same as gen 1.

Installation Instruction
Installation Instruction
Installation Instruction

If you have any questions do not hesitate to contact us. info@eurowise.com

Installation Instruction
Installation Instruction
Installation Instruction
Installation Instruction

Inner brackets are installed to existing exhaust hanger brackets and custom L bracket hardware.
Rearward brackets are mounted to subframe using the supplied nutserts.

IF YOU HAVE ANY QUESTIONS, COMMENTS, OR CONCERNS RELATED TO YOUR PRODUCT PLEASE CONTACT US!

CUSTOMERS SUPPORT

Logo

440 SPRINGBROOK ROAD. CHARLOTTE, NC 28217 | 704-559-8100
INFO@EUROWISE.COM | WWW.EUROWISE.COM | SHOP.EUROWISE.COM

QR Code

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals