ABYSM AB53002G2 Morpheo G2 ATX 850W Plus Gold Full Modular User Manual
- June 12, 2024
- ABYSM
Table of Contents
ABYSM AB53002G2 Morpheo G2 ATX 850W Plus Gold Full Modular User Manual
Warnings and Caution
- Do not unplug the AC power cord when the power supply is in use. Doing so may cause damage to your components.
- Do not place the power supply in a high humidity and/or temperature environment.
- High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician. Doing so will void the warranty.
- PSU should be powered by the source indicated on the rating label.
- All warrantees and guarantees will be voided, if failure to comply with any of the warnings and cautions covered in this manual.
Components Check – Power supply unit – User manual – AC power cord
Power Connector Introduction
Installation Steps
Note: Make sure that your system is turned off and unplugged. Disconnect the AC power cord from your old power supply.
- Open your computer case; Please refer to the direction in your case manual.
- Install the PSU into the case with the four screws provided.
- If your motherboard requires a 24 pin Main Power connector, please connect the 20+4 pin Main Power connector to the motherboard. If your motherboard only requires a 20pin Main Power connector, please detach the 4pin connector from the 20+4 pin Main Power connector then connect only the 20pin connector to the motherboard.
- .1 For motherboard that only requires a 4pin ATX 12V (CPU) connector, please detach a 4 pin connector from the 4+4 pin ATX 12V connector and connect it to the motherboard. (Either one of the 4 pin from the 4+4 pin ATX 12V connector will work).
4.2 For motherboard that requires a single Spin EPS connector, please use the 4+4 pin connector from the power supply.
- Connect other peripheral power connectors to devices such as hard drives, optical drives, etc.
- . If your graphic card requires PCI-E power connector, please connect corresponding PC IE connector instructed by your graphic card’s user manual. Please note the power supply utilizes an unique 6+2 pin PCI-E connector that can be effectively used as a single Spin or 6 pin PCI-E connector. To use it as a 6 pin PCI-E connector, please detach the 2 pin connector from the 6+2 pin connector.
- Close your computer case and connect the AC power cord to the power supply AC inlet.
Output Specification
Environments
Operating temperature: +0°C to +40°C Operating humidity: 20% to 90%, non- condensing MTBF: > 120,000 hours
MEANING OF THE DUSTBIN SYMBOL
Protect our environment: do not dispose of electrical equipment in your domestic waste. Please return any electrical equipment that you will no longer use to the collection points provided for their disposal. These simple steps can help to avoid the potential effects that incorrect waste disposal can cause on the environment and human health. This will contribute to recycling and other forms of re-use of electrical and electronic equipment. Information concerning where the equipment can be disposed of can be obtained from your local authorities.
MADE IN CHINA Imported by: COLORS Information Technology, SL. C/ Morse, 49 – Pol. Ind. San Marcos • 28906 Getafe (Madrid) CIF: B-84045574
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>