ORTECH FR-5CCT LED Slim Light User Manual
- June 17, 2024
- Ortech
Table of Contents
Instruction Manual 
LED SLIM LIGHTS
SLIMA4FL+FR-5CCT I SLIM6FL+FR-5CCT
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED
ELECTRICIAN.
- LED Slim lights are suitable for indoor use only. DO NOT use outdoors
- Please keep the LED Slim lights away from any corrosive substance, and please use dry cloth when you clean them
- LED Slim lights can only be installed by a qualified electrician
- Before installation or maintenance, please disconnect the power to ‘ prevent electric shock
APPLICATION NOTICE
- For your safety, this fixture MUST be wired in accordance to electrical codes and ordinances
- DO NOT open the light fixture and the side plates of driver – no serviceable part inside 2 HOUR FIRE
- DO NOT use any other driver except the ones advised by the supplier
- DO NOT connect multiple fixtures to one driver
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE
REFERENCES.
Electrical products can cause death or injury, or damage to property. If in
any doubt about the installation or use of this product, consult a competent
electrician.
INSTALLATION GUIDE
HOLE CUT SIZE
SLIM4FL+FR-5CCT: 4-1/4″(108mm)
SLIM6FL+FR-5CCT. 5-1/2″(140mm)
DRIVER WIRING:
STEP 1: Open the hardwire box swing cover and remove the appropriate
knockout(s).
STEP 2: Insert the electrical supply cable through the knockout and
secure with a cable connector (sold separately) .
STEP 3: Using wire nuts, connect green ground wire of cable to green wire
on box. Connect white wire of cable to white wire of box, Connect black wire
of cable to black wire of bo x (Fig. 1)
STEP 4: Place all wiring and connections back in to the box and close the
cover.
STEP 5: Insert hardwire box through the mounting hole. (Fig. 2) (Junction
box suitable for maximum of 5 No 12 AWG or 8 No 14 AWG conductors)
FIXTURE INSTALLATION:
STEP 1: Connect the fixture to the hardwire box by inserting and twsiting
the male/female connectors. (Fig. 3)
STEP 2: Push spring loaded clips on the fixture upwards and insert
fixture base in to the mounting hole. Release the clips and fixture will be
pulled flush to the ceiling. (Fig. 4)
STEP 3: Once assembly is complete, turn on power to confirm fixture is
working properly.
www.ortechindustries.ca
1.888.543.6473
13376 Comber Way, Surrey, BC V3W 5V9
205 Summertea Road,
Brampton, Ontario
info@ortechindustries.com
604.543.6473
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>