V I V O MOUNT-E-FD70S Electric Flip Down Installation Guide
- June 17, 2024
- V I V O
Table of Contents
Black Electric Flip Down / Swivel Ceiling TV Mount
SKU: MOUNT-E-FD70S/W
Instruction Manual
MOUNT-E-FD70S Electric Flip Down
ASSEMBLY VIDEO AVAILABLE:
Follow along step-by-step with our video walk through by scanning the QR code
with your mobile device or by following the product link: vivo-
us.com/products/mount-e-fd70s
Contact Us First!
DO NOT RETURN ITEM
Our friendly product support team is here to help!
PERSONABLE CUSTOMER SUPPORT
7AM – 7PM
Monday-Friday
| |
---|---|---
Give us a Call:
309-278-5303| Chat Us:
www.vivo-us.com| Email Us:
help@vivo-us.com
We’re Here for You!
Our customer-minded support team is here for YOU, Monday-Friday 7am-7pm CST.
We offer immediate assistance with rapid response times from customer service
agents and product techncians to help you every step of the way!
Missing a Part?
If any parts are received damaged / defective OR you are missing a part,
please reach out to us within 30 days of product delivery to have it replaced
at no cost.
We are happy to replace parts to ensure you have a fully functioning product
PRE-ASSEMBLY | BEFORE YOU BEGIN
If you do not understand these directions, or if you have any doubts about the
safety of the installation, please call a qualified technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual. Do not exceed
weight capacity. We cannot be liable for damage or injury caused by improper
mounting, incorrect assembly or inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD
STUDS TO MOUNT. We include mounting for brick and concrete walls. If unsure,
please contact us at vivo-us.com, email at help@vivo-us.com, or call us at
309-278-5303.
PITCH CEILING WARNING:
DO NOT attempt to install on a pitched ceiling. Mount will not operate as
intended.
WEIGHT CAPACITY
**** DO NOT EXCEED WEIGHT CAPACITY. Failure to do so may result in serious
injury.
Product Warranty
For the most up to date details on your product’s warranty, please visit the
product’s listing on our website or reach out to customer support.
vivo-us.com/products/mount-e-fd70s
Returns | Product Didn’t Work Out?
We offer a hassle-free 30 day return on all products. Contact customer support
at 309-278-5303 or help@vivo-
us.com. Please note: For items ordered in error or
no longer needed, the return shipping charges will be at the buyer’s expense.
TOOLS NEEDED:
PACKAGE CONTENTS
Please consult the parts list below and ensure you have everything you need to assemble your product. If parts are missing or damaged, please contact us.
ASSEMBLY STEPS
STEP 1: Installing the Mounting Brackets
For wooden joist mounting, determine what direction the joists run and the
direction you want the display mounted. Using the layout images, assemble
Mounting Brackets (D) to Mount (A) using M6x10mm Screws (S-F) and 4mm Allen
Wrench (T-B). For concrete ceilings, Mounting Brackets (D) can be assembled
in either orientation.
STEP 2: Mounting VESA Assembly
OPTION A: Wood Beam Ceiling
Using Ceiling Template (C), mark exact location of mounting holes. Drill pilot
holes 2.2” (55mm) deep using a 3/16” (4.5mm) drill bit. Insert two ST6.3x55mm
Screws (W-A) inline with the keyhole slots on the mount, leaving a 5mm gap
from ceiling. Hang Mounting Brackets (D) so that the screws fit into the
keyhole openings, then then slightly rotate the mount so the screw heads are
resting on the smaller hole. Tighten screws and secure using additional
additional ST6.3x55mm Screws (W-A) and Washers (W-C).
OPTION B: Concrete Ceiling
Using Ceiling Template (C), mark exact location of mounting holes. Drill pilot
holes 2.4” (60mm) deep, using a 3/8” (10mm) drill bit. Insert Concrete Anchors
(W-B) into drilled holes. Insert two ST6.3x55mm Screws (W-A) inline with the
keyhole slots on the mount, leaving a 5mm gap from ceiling. Hang Mounting
Brackets (D) so that the screws fit into the keyhole openings, then then
slightly rotate the mount so the screw heads are resting on the smaller hole.
Tighten screws and secure using additional additional ST6.3x55mm Screws (W-A)
and Washers (W-C).
STEP 3 : Assembling VESA Components
Assemble Bracket Rails (F) to Center Plate (B) using M6x25mm Screws (S-B), M6
Washers (S-C) and M6 Nuts (S-D). While holding M6 Nuts (S-D) with a wrench,
use a Phillips screwdriver to tighten M6x25mm Screws (S-B). Slide VESA
Brackets (E) onto Bracket Rails (F) and secure using M4x8mm Screws (S-E) and
3mm Allen Wrench (T-A).
STEP 4 : Adjusting VESA Assembly
Adjust VESA Brackets (E) spacing to match TV mounting holes, and lock in place
using M6x10mm Set Screw (S-A) and 3mm Allen Wrench (T-A).
STEP 5: Removing VESA Screws
Remove the four pre-installed screws from Center Plate (B) and loosen the
center screw until 5mm of thread is exposed.
STEP 6: Mounting VESA Assembly
Attach VESA assembly to TV using appropriate mounting Screws (M-A through
M-D), M8 Washers (M-E), and Spacers (M-F, M-G).
STEP 7: Place TV on Mount
Place the TV with VESA bracket assembly on Mount (A) by inserting the center
screw on Center Plate (B) into the keyhole on Mount (A) at the desired height.
Secure using previously removed screws (STEP 5) and tighten with a Phillips
screwdriver. Clearance between the ceiling and top edge of TV should be no
less than 15mm when TV is in the fully lowered position.
STEP 8 : Manage Cables
Remove the adhesive backing from Cable Clips (J) and place them on the side of
Mount (A).
Route Cables through Cable Clips (J) and use Cable Ties (I) to fasten cables
to the side of the arm.
STEP 9 : Connect AC Adapter
Plug AC Adapter (G) into Mount (A), and connect to AC outlet. Follow Remote
(H) instructions for operation.
CHECK OUT OTHER GREAT PRODUCTS FROM
EXPLORE MORE AT VIVO-US.COM
We offer a wide array of home & office products to fit your needs. From height
adjustable desks to monitor mounts to keyboard trays and more!
SPEAKER MOUNTS & STANDS
Whether you’re mounting a soundbar or surround sound system, we’ve got a
mounting solution to fit your needs
https://vivo-us.com/collections/speaker-mounts-and-stands
HEIGHT ADJUSTABLE DESKS
We offer electric & manual crank standing desks, corner frames, desk & top
combos, and more!
https://vivo-us.com/collections/standing-desks
MONITOR MOUNTS
From single monitor mounts to hex mount, gromment or clamp-ons, we’ve got a
mounting solution for your setup.
https://vivo-us.com/collections/monitor-mounts
WHO WE ARE
VIVO is more than a brand of ergonomic office furniture. We are a team of
creative and innovative indivuduals working together to offer high quality,
affordable ergonomic solutions. We think and work outside of the box to serve
you, our customer, to the best of our abilitiy.
Need Assistance?
We Would Love to Help!
Personable Customer Support | Mon-Fri 7am-7pm
We offer immediate assistance with rapid response times from customer service
agents and product techncians to help you every step of the way!
| Call Us: 309-278-5303
Average Resolution Time: 5m 4s
---|---
| Chat Us: www.vivo-us.com
Average Resolution Time: < 15m
| Email Us: help@vivo-us.com
Average Resolution Time: 1HR 8M
23% within < 15m
38% within < 30m
61% within < 1hr
83% within <2hr
92% within < 3hr
LOVE YOUR NEW VIVO SETUP?
Ready to share that new amazing setup?
Want to brag about that amazing new ergonomic solution?
Tag us in your photo!
FOR MORE GREAT VIVO PRODUCTS,
CHECK OUT OUR WEBSITE AT: WWW.VIVO-US.COM
LAST UPDATED: 05/30/2023
REV1.1LF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>