TRIKDIS DSC PC1832 Wiring GT Plus Cellular Communicator and Programming the Panel User Guide
- June 17, 2024
- TRIKDIS
Table of Contents
- TRIKDIS DSC PC1832 Wiring GT Plus Cellular Communicator and Programming
- Product Usage Instructions
- Schematics forwiring the communicator to the security control panel
- LED indication of communicator operation
- Setting up the GT+ communicator with the app
- Setting up the GT+ communicator with the app
- FAQ
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
TRIKDIS DSC PC1832 Wiring GT Plus Cellular Communicator and Programming
the Panel
Specifications
- Model: PC1832
- Compatible with Trikdis GT+ Cellular Communicator
- LED Indicator for communicator operation
- Support for 4G network
CAUTION
- The communicator should be installed and maintained by qualified personnel.
- Prior to installation, it is advised to read full device installation manual carefully in order to avoid mistakes that can lead to malfunction or even damage the equipment.
- Disconnect the power supply before making any electrical connections.
- Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty.
Product Usage Instructions
Wiring the Trikdis GT+ Cellular Communicator to the Panel
- Refer to the provided schematics for wiring guidance.
- Connect the communicator to the control panel following the wiring diagram.
Programming the Panel
The DSC PC1832 panel does not require additional programming.
Setting up the GT+ Communicator with the App
- Download and launch the Protegus application or access the browser version at web.protegus.app.
- Installer must log in to Protegus with an installer account.
- Follow the steps below:
- Click on ‘Add new system’ button.
- Enter the IMEI number of the communicator.
- Select the security company.
- Press ‘DSC’ and then ‘PC1832’.
- Enter Object ID and Module ID. Press ‘NEXT’.
- Press ‘Add to Protegus’.
- Enter system name and press ‘Next’.
- Press ‘Skip’ and then press on the system.
- Wait for a minute and press ‘Transfer’.
System Check
After setup and installation, perform a system check by:
- Create an event by arming/disarming the system or triggering a zone alarm.
- Ensure the event reaches the Central Monitoring Station (CMS) and Protegus app.
- Enter the email of the user for system transfer and press’Transfer’.
- The system will be available in Protegus on the user’s phone.
Schematics forwiring the communicator to the security control panel
Following the schematics provided below, wire the communicator to the control panel.
DSC PC1832 panel do not need to be programmed.
LED indication of communicator operation
Setting up the GT+ communicator with the app
Download and launch the Protegus application or use the browser version: web.protegus.app. The installer must connect to Protegus with an installer account.
Setting up the GT+ communicator with the app
After completing the setup and installation perform a system check:
- Create an event:
- by arming/disarming the system with the control panel’s keypad;
- by triggering a zone alarm when the security system is armed.
- Make sure that the event arrives to the CMS (Central Monitoring Station) and the Protegus app.
FAQ
Q: Do I need to program the DSC PC1832 panel?
A: No, the DSC PC1832 panel does not require additional programming.
Q: How can I check if the GT+ Communicator is connected to the cellular network?
A: Check the LED indicator status. A solid green light indicates the communicator is connected to the cellular network.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>