Super E- Caddy Remote Electric Cart Instruction Manual

Super E- Caddy – Remote Electric Cart
Instruction Manual

PARTS LIST

1. Handle
2. Speed Control Knob
3. Control Panel
4. Horizontal Arm
5. Adjustment Knob
6. Vertical km

| 7.Wheelie Bar
8.Battery Port
9.Battery
10.Bag Straps
11.Alignment Bolts
12.Bag Holder
---|---

HANDLE FEATURES

1. Scorecard Holder
2. Storage Compartment
3. Golf Ball Holders (2)
4. Tee Holder (4)
5. Drink Holder

| 6.Drink Holder
7.Speed Control Knob
8.Control Panel
9.Remote Mount
---|---

INCLUDES

A.Super E Cart
B.Battery
C.Charger

INITIAL SETUP: WHEEL INSTALLATION

The Super E will require some assembly once it is removed from the package:

1. Remove all wrapping and rubber axle caps.
2. The wheels will need to be attached for use. In order to attach the wheels. Push and Hold the silver push pins on each of the wheels.
3. Slide the wheel over the axle. On each of the wheels are 4 hex bolts. These bolts fit into the holes on the axle hub of each side. The wheel will install correctly when the 4 hex bolts fit into the 4 holes on the axle hub.
4. On each axle there are 2 grooves for the wheel pins to lock into:
5. The first groove keeps the wheels on the cart but does not connect the wheels to the This allows the cart to be used as a traditional pushcart in the event that your battery dies or would like to push the cart manually.
6. The second groove connects the wheels to the motors.
7. The wheel will be correctly connected to the motor when the 4 bolts fit into the 4 corresponding holes on the axle hub. Also, the wheel will sit flush against the axle hub rather than have space.

Axle with 2 Grooves:

FIG. 1 – Wheel is installed on the first axle groove. The motor is not engaged & the cart can be manually pushed without resistance from the electric motors. The cart will not move using the motors if the wheels are installed on the first groove.

FIG. 2 – The wheel  is installed on the second groove. The cart will now move using the motors. Notice the wheel sits flush against the axle hub.

The rear wheelie bar will also need to be attached for use:

• In order to attach. pull up on the knob located on the wheelie bar and slide onto the square bar located on the back of the cart.
• The Wheelie bar will lock into the corresponding hole on the back of the cart. The wheelie bar will *click’ into place.
• There are two angles for the wheelie bar:
• The lower position is recommended to keep the cart stable on all terrain.
• It is not recommended to use the higher wheelie bar setting unless the cart is being towed. Once the wheels and wheelie bar have been installed, the cart is ready for use.

CHARGING THE BATTERY

BATTERY SPECIFICATIONS:

• Lithium-Ion battery pack: 25.2 V, 10Ah output. 2000mA
• The Lithium-ion battery will run the cart for 18-27 holes. It is recommended that you charge the battery after every use.
• Store the battery with a full charge when not in use.
• Do not leave the battery connected to the cart when the cart is not in use. Make sure the battery port and plug are covered when not in use.
• To charge the battery
•  First, connect the battery to the charger
• Next, plug the charger into the outlet.
• The LED indicator on the charger will turn red when the battery is charging and will turn green when the battery is fully charged.
• When the battery is fully charged unplug the charger from the outlet.
• Next, disconnect the battery from the charger.
• The battery is now ready for use.
• Charging time can range from 3 to 6 hours depending on previous use
• Do not store the battery completely drained. This can lead to a shorter lifespan of the battery.
• Do not overcharge your battery. charging will end when the indicator light on the charger is green.
• Only use the included charger to charge the battery.
• CAUTION: do not contact the battery plug pins to any metal object. This may cause electric shock and possible injury.

OPERATION

• First, strap the battery down on the cart so it does not move during operation.
• Plug a fully charged battery to the cart. The plug and port have grooves to specifically align the battery into the cart battery port as well as a red line on the port and the Align the red mark on the plug and port to correctly install. Make sure you remove the port cover on the cart before trying to connect the battery.
• Once you align the grooves on the battery plug and port, connect the battery to the cart port and twist the silver locking collar to ensure the battery remains connected to the cart during use.
• When the battery is not connected, use the plug cover to protect the port from any debris.
  

TO POWER CARTON

Connect a fully charged battery to the cart 8 Hold the Power Button located on the cart handle until the power indicator light turns green. To turn the cart off. Hold the Power Button until the green light turns off.

• The “7” Symbol above the power button is the Timer Pressing this runs the cart for set distances:
• Pressed Once: T1: 15 yards
• Pressed Twice: T2: 23 yards
• Pressed 3 Times: T3: 37 yards
  

Below the power button is 2 indicator lights: a battery symbol and a star symbol.

• The battery shaped Indicator light will emit green when the battery has enough power and is okay for use
• The star-shaped indicator light will be red when the battery is low and needs to be charged.

SPEED CONTROL KNOB

• The silver knob located by the power button 8 timer button Is the Speed control adjustment.
• This knob controls how fast the cart runs without the remote.
• The remote can only be used to stop the cart by pressing the middle ‘circle” button once.
• This knob is used for walking behind the cart without using the remote. The cart will only move forward when using the speed control knob.
• To increase speed, turn the knob clockwise; to decrease speed, turn the knob counterclockwise. To stop the cart, turn the knob counterclockwise until the knob does not rotate any further. Also, pressing the power button once on the cart handle will stop the cart.

Do not touch the knob If you are not ready for the can to move. The Cart will continue to move until the knob Is turned to the off position. Also, pressing the power button once or pressing the middle button on the remote will stop the cart.

REMOTE CONTROL LAYOUT

1. Forward
2. Reverse
3. Left
4. Right
5. Stop

| 6.Play/Pause
7.On/Off Switch
8.Clip/Mount
9.CI Antenna
10.LED Indicator
---|---

• To turn the remote on, slide the switch on the side of the remote towards the antenna. Make sure to turn the remote control off when it is not in The remote will not shut off automatically. The remote requires 2 AAA batteries.
• When using the remote, make sure your hand is not covering the antenna needs to move freely for optimal range.
• To Sync the remote: If the cart does not respond using the remote:

1. Check to make sure the battery is connected properly & that the green power light is on. Also, make sure the remote is switched on and the red LED indicator light blinks when buttons are pressed.
2. Power the remote on first, then power the carton so the green light indicator on the cart handle is on.
3. With the speed control knob turned fully counterclockwise (off position): rotate the speed control knob roughly 20 degrees clockwise until there is a ‘click’. Do not rotate the knob any further once you hear the ‘click’.
4. press any button on the remote. The cart should respond from the remote input,
5. After the cart and remote have synced and the cart is now responsive from remote input, turn the speed control knob fully counterclockwise (back to off position).
6. The cart should now automatically sync with the remote whenever the remote and cart are powered on.
7. If the cart becomes unresponsive again from remote input, repeat the process of syncing the remote and cart

• The can has three speeds in each direction:

1. UP – Forward (3 speeds by pressing: once. twice, 3 times)
2. DOWN – Reverse (3 speeds by pressing: once. twice. 3 times)
3. Arrow L – Left Turn (single clicks or holding)
4. Arrow R – Right Turn (single clicks or holding)
5. ‘ Circles (middle button) • Stop
6. Play/Pause: this button runs the cart in the forward direction for distances:

• One-Press: the cart runs for 20 yards
• Two Presses: the cart runs for 35 yards
• Three Presses: the cart runs for 50 yards
• Note: you can stop the cart by pressing the ‘circle’ button at any time as well as steer the cart using the arrow buttons.

CART HANDLE ADJUSTMENT

• To adjust the angle of the cart handle, loosen (rotate counterclockwise) the black knob with the located near the upper bag holder.

Adjust the handle to the desired angle and rotate the knob clockwise to tighten

Caution: When adjusting the handle, loosen the knob enough so there is a space between the “teeth” on the cart handle. If the knob is not loosened enough, the “teeth” can wear and cause adjustment issues.

SECURING BAG TO CART

• One end of the straps has a loop and the other end has a plastic ball attached. The loop goes around the ball to secure your bag using tension.
• There is an upper bag strap and a lower bag strap.
• The bottom of your golf bag rests on the 2 angled frame pieces which have a plastic ball attached to the ends.
• If you need more tension on the bag straps to hold your bag in place, tie knots in the straps to increase the amount of tension.

REMOTE MOUNT

• On the back of the cart handle, there is a plastic “ring”. If you would like to secure the remote to the cart, the remote clip can slide into the “ring” for convenient remote placement.
• Store remote control in the closable compartment when the remote is not in use & during transportation.

TRANSPORTATION

• Fold the handle down & tighten the adjustment knob Securing arm to the cart:
• With the cart handle folded down, use the lower bag strap (the end with the ball attached) & loop around the upper bag holder
• Secure bag strap loop to the silver ring mounted on the cart frame. The silver ring is located in front of the cart battery.
• Removing wheels: removing the wheels and wheelie bar for transportation is based upon the users’ needs.
  

GENERAL MAINTENANCE & CAUTION

• Do not submerge the cart in water. The cart is water-resistant but is not fully waterproof.
• Do not use pressured water to clean the cart.
• The cart can be used in light
• Store the battery in a warm and dry place (not on a concrete floor).
• The battery is not waterproof. Do not use a cart in heavy rain.
• The cart remote is not waterproof. Use caution when using the remote in the rain.
• When cleaning the cart:
• The best way to clean the Callaway Traverse is to wipe off any excess dirt/grass with a wet This reduces the risk of damaging the electronics in the cart.
• To clean the wheels: remove both rear wheels and rinse using water or wipe wheels using a clean towel. Do not use high-pressure water to clean the cart. Clean the front wheel by using water and a clean towel to wipe excess grass and mud away.
• Do not store the battery completely drained. This can lead to a shorter lifespan of the battery.
• It is recommended that you store the lithium-ion battery with at least 50% of charge.
• Do not overcharge your battery: charging will end when the indicator light on the charger is green.
• Do not completely drain the battery. Once the low battery light is on, do not use the motors. Put the cart into manual mode by moving the cartwheels to the first axle groove so the cart can be pushed freely.
• Do not use any sort of lubricant on the cart axles or bearings. They are designed to be debris-resistant and do not require lubrication.
• CAUTION: do not contact the battery plug pins to any metal object. This may cause electric shock and possible

Bluetooth Speaker Operation

Your Super E-Caddy comes with a magnetic Bluetooth Speaker. Please fully charge the speaker before using, with the supplied USB charger wire. On the bottom of the speaker, you will see 3 buttons. The largest one is the power on the button. To turn it on, press and hold a large button for 5 seconds. The plus and minus buttons control volume. After powering on, go to Settings on your cell phone and turn on Bluetooth. You will see BY-01 as an available device. Press that and the speaker will pair to your phone. This will only need to be done once. Then simply attach it to the plate just under the bar near the cart keypad. The volume can also be controlled from the phone. The metal plates with adhesive backing are supplied that you can use the speaker on non-metallic surfaces.

Warranty Information

The Super E Caddy comes with a 12-month warranty which covers manufacturers’ defects and abnormal wear. The warranty does not cover normal wear and tear or abuse/accidents caused by the operator. Only use the battery and charger that came with the cart. All purchases are returnable within 30 days if returned in the original box for a full refund.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>