TRIKDIS Ademco Vista-15 Cellular Communicator and Programming the Panel User Guide
- June 17, 2024
- TRIKDIS
Table of Contents
TRIKDIS Ademco Vista-15 Cellular Communicator and Programming the Panel
Safety Precaution
CAUTION
- The communicator should be installed and maintained by qualified personnel.
- Prior to installation, it is advised to read full device installation manual carefully in order to avoid mistakes that can lead to malfunction or even damage the equipment.
- Disconnect the power supply before making any electrical connections.
- Changes, modifications or repairs not authorized by the manufacturer shall void your rights under the warranty.
Schematics for wiring the communicator to the security control panel
Following the schematics provided below, wire the communicator to the control panel.
- Honeywell Ademco Vista-15
Instructions for use
Programming the Honeywell Ademco Vista-15 Alarm Panel via Keypad
Using the control panel’s keypad enter these sections and set them as described:
Enable Contact ID reporting
| Keypad Entry | Action Description |
|---|---|
| 4112800 | Enter programming mode |
| 591 | Enable “Exit Error Report Code” |
| 601 | Enable “Trouble Report Code” |
| 611 | Enable “Bypass Reporting Code” |
| 621 | Enable “AC Loss Report Code” |
| 631 | Enable “Low Battery Report Code” |
| 641 | Enable “Test Report Code” |
| 651 | Enable “Open Report Code” |
| 661 | Enable “Arm Away/Stay Report Code” |
| 671 | Enable “RF Transmitter Low Battery Report Code” |
| 681 | Enable “Cancel Report Code” |
| 691 | Enable “Recent Closing Report Code” |
| 701 | Enable “Alarm Restore Report Code” |
| 711 | Enable “Trouble Restore Report Code” |
| 721 | Enable “Bypass Restore Report Code” |
| 731 | Enable “AC Restore Report Code” |
| 741 | Enable “Low Battery Restore Report Code” |
| 751 | Enable “RF Transmitter Low Restore Code” |
| 761 | Enable “Test Restore Report Code” |
| 291 | Enable “Enable IP/GSM” |
| 1891 | Enable “AUI Device Enable” |
| *99 | Exit programming mode. |
Setting up the GT+ communicator with the app
Download and launch the Protegus application or use the browser version : web.protegus.app. The installer must connect to Protegus with an installer account.
-
Step 1
Click the “Add new system” button.
-
Step 2
Enter the IMEI number of the communicator
-
Step 3
Select security company
-
Step 4
Press “Honeywell”
-
Step 5
Press “VISTA 15”
-
Step 6
Enter “Object ID” and “Module ID”. Press “NEXT”
-
Step 7
Wait while the configuration is written.
-
Step 8
Press “Add to Protegus2”
-
Step 9
Enter system “Name”. Press “Next”
-
Step 10
Press “Skip”
-
Step 11
Press on system
-
Step 12
Wait 1 minute and press “Transfer”
-
Step 13
Enter the e-mail of the user to whom the installer will transfer the system. Press “Transfer”
-
Step 14
The system will appear in Protegus on the user’s phone.
After completing the setup and installation perform a system check:
- Create an event:
- by arming/disarming the system with the control panel’s keypad;
- by triggering a zone alarm when the security system is armed.
- Make sure that the event arrives to the CMS (Central Monitoring Station) and the Protegus app.
Customer Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>