MB QUART BQG-FPOD-1 Front Speaker Instruction Manual
- June 4, 2024
- MB QUART
Table of Contents
MB QUART BQG-FPOD-1 Front Speaker Instruction Manual
Installation Instructions
Model: | Polaris General |
---|---|
Description: | Front Speaker Install |
Part Number: | MBQG-FPOD-1 |
Assembly Time: | 30 Min |
Before you begin, read through these instructions and check that all parts are present. Always disconnect negative battery terminal prior to installation. Please note that MB Quart cannot assume any responsibility for damage resulting from incorrect installation.
Parts List
No.| Component Name| Qty
1| 6.5” Dash Speakers (MBQG-FPOD-1)| 2
Tools Required
1| 11/32” Drill Bit
2| Drill
Front Speaker Pod Install
-
Connect speaker wires and then hold passenger side pod up high to the dash till it slides into place.
-
Using 11/32” drill bit, drill the four holes and secure with four push pins
-
Repeat on the driver side and drill the five lower holes with 11/32” drill bit and secure with five push pins
FCC Notice
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
mobile installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
WARNING: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complied with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
WARRANTY
Maxxsonics USA Inc. warrants this product, to the original consumer purchaser,
to be free from defects in material and workmanship for a period of one (1)
year from the date of purchase. Maxxsonics USA Inc. will, at it’s discretion,
repair or replace defective products during the warranty period. Components
that prove to be defective in materials and workmanship under proper
installation and use must be returned to the original authorized Maxxsonics
USA Inc. retailer from where it was purchased. A photocopy of the original
receipt must accompany the product being returned. The costs associated with
removal, re-installation and freight are not the responsibility of Maxxsonics
USA Inc. This warranty is limited to defective parts and specifically excludes
any incidental or consequential damages connected therewith. To view the full
warranty, please visit the website.
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use such marks by MB Quart is under license.
All product names, logos, and brands are property of their respective owners.
All company, product and service names used in this literature are for
identification purposes only. Use of these names, logos, and brands does not
imply endorsement.