TECNO TE215 Electronic Recessed Thermostat User Guide
- June 4, 2024
- TECNO
Table of Contents
TE215 Electronic Recessed
**Thermostat User Guide
**
ELECTRONIC RECESSED THERMOSTAT – RAFFAELLO – TE215
CONFORME ALLE MORE
IN CONFORMITY WITH NORMATIVE
60730-1, EN 60730-2-9, EN 60730-2-7
WARNINGS BEFORE INSTALLATION
- The device must be installed by qualified personnel.
- The device must be positioned about 1.5 meters above the floor, avoiding heat sources, windows, and doors.
- The device must be installed in three modules of recessed boxes type 503E.
- Two interchangeable faceplates are supplied white and charcoal gray. The white front panel is pre-installed. If you want to change the color, follow the procedure described in the paragraph ‘FRONT PANEL REPLACEMENT.
- Inserting the batteries incorrectly could damage the device.
INSTALLATION
- Choose faceplates to use.
- Remove the device from its casing using the ejecting pull tab and remove the battery cover at the bottom of the appliance with a flathead screwdriver.
- Insert 2 batteries AA alkaline 1.5 V, respecting the polarity indicated on the bottom, and reassemble the battery cover.
- Choose among the 4 universal supports supplied the one compatible with the plate in possession (SEE SUPPORT INSTRUCTIONS) and install the thermostat following the order indicated in fig1
FRONT PANEL REPLACEMENT
The device comes with a factory-installed white faceplate. To replace it with a different color, proceed as follows:
- Turn the knob on to 5°C and make sure the switch is OFF. ****
- Unhook the front panel, so also the knob, from the device by prying with a flat-head screwdriver in the two side slots on the right side (ejecting pull tab side) and remove it from the device.
- Remove the ejecting pull tab (down to the right) by pulling it out first, then turn it down to pull it out of its housing. Then assemble the extraction tab of different colors, following the procedure inverse to that of disassembly.
- Align the right part of the front panel of different colors to the side hooks and eject the pull tab, so press on the left side to fit it. Place the knob indicator at the value 5°C and press on the knob until it beats.
ELECTRICAL CONNECTIONS
Connect the two wires of the heating/cooling system to the screw terminals on the back of the device following the diagrams in Fig. 2A e Fig. 2B
OPERATION
The device can adjust heating and cooling systems:
- Placing the switch SW to the left , the device works in cooling mode
- Placing the switch SW to the right the device works in heating mode
- To turn off your device, place the switch SW in the center OFF
TEMPERATURE SETTING
Use the knob to adjust the desired temperature with a range from 5 to 30°C. When the system is running, the LED Indicator 12 (load) flashes red every 5 seconds.
BATTERY CHARGE CONTROL
Press the button T1 (test):
- if the led indicator (Li) lights up, batteries are charged
- if the led indicator (Li) is off, batteries are low. You have to replace it
Pursuant to Legislative Decree No. 49 of March 14, 2014 “Implementation of
Directive 2012/19 / EU on waste electrical and electronic equipment (WEEE)”
The”crossed out wheelie bin” WEEE symbol on the appliance show that the
product at the end of its useful life must be collected separately from other
waste, Therefore, the user must provide the equipment with the essential
components at the recycling center for electronic and electrotechnical devices
or return it to the dealer when you purchase an equivalent appliance in one to
one reason, or 1 to zero for equipment with a side
lower than 25cm. Correct recycling helps to avoid possible negative effects on
the environment and on health favoring the recycling of the materials that
make up the equipment. The illegal disposal of the product by the user
involves administrative sanctions as per Legislative Decree No. 49 of March
14, 2014.
REV 07-22
Tecno Switch reserves the right to make changes to its products at each moment
and without further notice. Tecno Switch declines all responsibility for
damage to things or persons derived from incorrect or improper use of its
products. For more information consult the Installer manual on our website
(tecnoswltch.com)
tecnoswitch.com arealed.it
Via P Leone Dehon, 99/105
76123 Andria (BT) ITALY
tel (+39) 0883 555323
fax (+39) 0883 555323
Documents / Resources
|
TECNO TE215 Electronic Recessed
Thermostat
[pdf] User Guide
TE215 Electronic Recessed Thermostat, TE215, Electronic Recessed Thermostat,
Recessed Thermostat, Thermostat
---|---