TECNO SPARK 20 Smart Phone User Manual

TECNO SPARK 20 Smart Phone

Specifications:

• Model: SPARK 20
• Operating System: HiOS based on Android™ OS
• Front Camera : 8W Camera
• Rear Camera : 32M Camera
• Processor: Main Board
• Memory: 8GB RAM, 128GB internal storage
• Display: LCM 3, 6.5-inch screen
• Battery : 4000mAh

Product Usage Instructions:

Know your phone:

The phone features a front camera, volume keys, power key with a side fingerprint sensor.

SIM/SD Card Installation:

1. Power off the mobile phone.
2. Refer to the provided picture for proper SIM/SD card installation.

Charging the Phone:

To charge the device:

• Use the provided TECNO charger and USB cable.
• You can charge using a charger or by connecting to a computer.
• Using other chargers may damage the device and void the warranty.

FCC Caution:

The device complies with FCC rules. Please adhere to the following:

• Avoid causing harmful interference.
• The device must accept any received interference.
• Do not make changes that are not approved as it may void user authority.

Specific Absorption Rate (SAR) Information:

The mobile phone meets government standards for exposure to radio waves, ensuring safety guidelines are met.

Disclaimer:

HiOS runs on Android™ OS which is a trademark of Google LLC.

FAQ:

• Q: Can I use any charger to charge my SPARK 20?
  • A: No, it is recommended to use only the TECNO charger and cables provided with the phone to prevent damage and maintain warranty validity.
• Q: What should I do before installing a SIM or SD card?
  • A: Make sure to power off your mobile phone before proceeding with the installation to avoid any issues.

Explosion diagram specification

Know your phone

1. Front Camera
2. Volume + key
3. Volume – key
4. Power key & side fingerprint sensor

SIM/SD card installation

1. Power off mobile.
2. Refer to the following picture for SIM / SD card installation.

Charging the phone

• You can charge your device using a charger or by connecting it to the computer using a USB cable (which comes with the phone).
• Use only the TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.

FCC Caution

Labeling requirements.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation. Information to the user.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement The SAR limit of the USA

(FCC) is 1.6 W/kg averaged over one gram of tissue.

Device types:

KJ5 (FCC ID: 2ADYY-KJ5) has also been tested against this SAR limit.

The highest SAR value reported under this standard during product certification for use at the ear is 1.25 W/kg and when properly worn on the body is 1.05W/kg.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

HiOS runs on AndroidTM OS.

Android is a trademark of Google LLC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>