TAG-N-TRAC V08G07J17 Temperture Humidity Motion Light Pressure Sensors User Guide

Linkedin
Scan QR code
https://www.linkedin.com/company/aovxassetstracker/mycompany/?viewAsMember=true

OVERVIEW

GOODS MONITORING ST300air

FEATURES

General Specification

<1s

Global Network
Variant for the Global

Buffer Storage:

Hardware Features

Sensor

Motion Sensor| Gravity Measurement Range: ±2g/±4g/±8g/±16g
ODR Bandwidths: 1Hz ~ 400Hz
---|---
upper/ bottom Light Sensor| Measuring Range: 1~ 100T0 (adjustable levels)
Temperature and Humidity Sensor| Humidity Measurement Accuracy: ±2% RH
Temperature Measurement Accuracy: ±0.5°C , – 40°C~+55°C
Battery Capacity| 13000mAh

Air Protocol

LTE (Cat 1)| LTE FDD: Max 10Mbps (DL)/Max 5Mbps (UL)
LTE TDD: Max 8.96Mbps (DL)/Max 3.1Mbps (UL)
---|---
GSM| GPRS: Max 107Kbps (DL)/Max 85.6Kbps (UL)
EDGE: Max 296Kbps (DL)/Max 236.8Kbps (UL)
Transmit Protocol| TCP , MQTT
Working Modes| Power saving mode for long standby time
Continuous mode for emergency tracking
Scheduled Timing Report| Report position and status at preset time intervals
Geo-fences| Support up to 5 internal geo-fence regions
Low Power Alarm| Alarm when internal battery is low
Wakeup Report| Report when the device wakes up
Motion Detection| Motion detection based on internal 3-axis accelerometer

FCC part
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

• Under Development

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>