Fittes Flush Floor Vent Lite Supply Installation Guide
- June 17, 2024
- Fittes
Table of Contents
Fittes Flush Floor Vent Lite Supply
Instruction for use
-
Drop in base on subfloor. If required, fasten with wood screws. *DO NOT use provided screws here.
-
Install surface material on top of Base so that it is completely flush.
-
Dry fit Body into Base.
-
With the resistance from the flange, adjust Body up and down until it is flush with the top of surface.
-
Once adjusted to prefered height, fasten the Body to the Base using provided screws through the four pilot holes in each corner.
-
Backfill Tray with bonding material and place precut piece of surface material inside Tray.
-
Hold in place and flip Tray. Apply even pressure until surface material lies flat with the rim of Tray. Leave to cure.
-
Insert and slide Tray in place. Enjoy!
Customer Support
Control Air Flow
Slide to remove tray and adjust flange open and closed. For optimal air
flow, push flanges past 90º.
Additional Support
support@fittes.com /
www.fittes.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>