Fittes FMLIT2X12BLK Flush Floor Vent Lite Instruction Manual

Flush Floor Vent [Lite]
Install Guide

FMLIT2X12BLK Flush Floor Vent Lite

1. Drop in base on subfloor and fasten with wood screws.
   *DO NOT use provided screws here.
2. Install surface material on top of Base so that it is completely flush.
3. Dry fit Body into Base.
4. With the resistance from the flange, adjust Body up and down until it is flush with the top of surface.
5. Once adjusted to preferred height, fasten the Body to the Base using provided screws through the four pilot holes in each corner
6. Backfill Tray with bonding material and place precut piece of surface material inside Tray.
7. Hold in place and flip Tray. Apply even pressure until surface material lies flat with the rim of Tray. Leave to cure.
8. Insert and slide Tray in place. Enjoy!

Control Air Flow
Slide to remove tray and adjust flange open and closed. For optimal air flow, push flanges past 90º.
Additional Support
support@fittes.com
www.fittes.com
Made in Canada

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>