RunCam SPLIT-HD-3DM Split HD Camera User Manual

June 4, 2024
RunCam

RunCam SPLIT-HD-3DM Split HD Camera.

RunCam-SPLIT-HD-3DM-Split-HD-Camera-product

Instruction Diagram

RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-1

Lens Module Connection Diagram

RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-2

Micro SD Card

Capacity up to 128GB; U3 recommended (2.7K50/1080P120 requires U3 or above; other solutions require U1 or above).

Please push the shield a little bit up with one hand like showed in above (step 1) and then press the SD card(step 2) with another hand to let the card pop out.

Basic Camera Operation

RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-4

Power Supply and Remote UART Control Connection Diagram

RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-5

Warning:
Current Input ≥1A (Don’t powered by VTx).

Flight Controller UART Control

Preparation

  • Firmware: BetaFlight Firmware (≥3.2.0),CleanFlight Firmware(≥2.1.0) , KISS Firmware (≥1.3-RC30) or INAV Firmware (≥1.7.3).
  • Any available UART interface on the Flight Controller
  1. Connect the RunCam Split HD with the UART interface of the Flight Controller

  2. Make the Flight Controller recognize the RunCam Split HD
    For example , we connect the RunCam Split HD to the UART 5 interface on the Flight Controller: connect the Flight Controller to the computer, then open the configurator software of the Flight Controller. (Open up the configurator that matches the firmware you are running, Betaflight Configurator for Betaflight, Cleanflight Configurator for Cleanflight). In the Peripherals column of the line UART 5 (on the Ports tab), select Camera (RunCam Protocol) and click Save And Reboot.RunCam-SPLIT-HD-3DM-Split-HD-
Camera-fig-6

  3. Instructions of the functions of the camera and assigning transmitter channels to them

In the Flight Controller Configurator, navigate to the Modes tab. There are new CAMERA WI-FI, CAMERA POWER and CAMERA CHANGE modes

  • CAMERA POWER: start/stop the video. When in the OSD of the camera, this is used to move to the next menu item.
  • CAMERA CHANGE MODE: Switch between the recording mode and the QR code setting mode

Assign any available channel to the function you need, for example:

  • Assign the AUX2 to the CAMERA POWER, range 1900-2100
  • Assign the AUX3 to the CAMERA CHANGE MODE, range 1900-2100RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-7

Assign the channel to the switch of the controller
Please choose your Model on the controller, then access to the MIXER interface and assign the channel to the switch of the controller. Take opentx 2.2.0 for example, assign the channels CH5, CH6 and CH7 to SA, SB and SD respectively.RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-8

Test

Power the Flight Controller and the RunCam Split HD

  • Set the SA to the bottom, the camera starts/stops the video
  • Set the SD to the bottom, the camera switches among the two modes: video and OSD setting mode.

Technical Support

Please visit https://support.runcam.com.

Parameter

RunCam-SPLIT-HD-3DM-Split-HD-Camera-fig-9

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals