PIMA INP514 Electronic Systems Instruction Manual
- September 21, 2024
- PIMA
Table of Contents
PIMA INP514 Electronic Systems
The sticker above includes the product info and the link to its literature.
Safety Instructions
This product has been registered in accordance with international safety
standards.
These standards require to inform you the following information:
- There are hazards of fire and electric shock in the alarm system and its peripherals. To reduce the risk of fire or electric shock, do not expose this alarm system to rain or moisture. Pay attention: Telephone cords could be a good conductor for lightings energy.
- Warning : this equipment has no mains On/Off switch. For external power supply source, the plug of the direct plug-in AC power is intended to serve as the disconnecting device. For internal transformer source, a circuit breaker can be used as the disconnecting device.
- Dangerous high voltages are present inside the control panel’s enclosure. Refer servicing to qualified personnel only.
- The control panel of the alarm system should be used with 230VAC/110VAC, 50/60Hz, protected by anti-electric shock breaker. Use only the power supply provided with this equipment. Use of unauthorized power supplies may cause damage.
- Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the unit, immediately consult a qualified service.
- Replace batteries only with the same type. Do not mix old and new batteries. Disposal of used batteries must be made in accordance with local waste recovery and recycling regulations.
Force
Manufactured by:
PIMA Electronic Systems Ltd.
5, Hatzoref St., Holon 5885633, Israel
Tel : +972.3.6506414 Fax: +972.3.5500442
www.pima-alarms.com
Email : support@pima-alarms.com
P/N: 4410548 Rev. A (May. 2022)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>