Runcam 4ZHSZQ4G8 Edition FPV Sports Ultra HD Camera User Manual
- May 15, 2024
- RunCam
Table of Contents
- Diagram
- Camera Module Connection
- Basic Camera Operations
- MicroSD Card
- HDMI Connection
- Firmware Update
- PWM Remote Control
- Steps to configure
- Specifications
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
- resource motor 6 none
- resource pinio 2 B05
- set pinio_ config = 129,129,1,1
- set pinio_ box = 0,41 ,255,255
- save
Runcam 4ZHSZQ4G8 Edition FPV Sports Ultra HD Camera
Diagram
Camera Module Connection
Basic Camera Operations
Power on/off
To power on, long press the Power/ Shutter button, the power light indicator is on, camera gets turned on.
To power off, long press the Power/ Shutter button, the power light indicator goes off, camera gets turned off.
Video mode
After turning on the camera, short press Power/Shutter button, the power
indicator blinks slowly, camera starts to record.
When the camera records, short press the Power/Shutter button, the power
indicator stays solid, camera stops recording.
Abnormal Conditions
Card error (no card, card full or low-speed card etc.): light blinks red quickly.
Abnormal booting: camera fails to detect the module, red light blinks slowly for 2 seconds, and camera shuts off after 5 seconds.
MicroSD Card
Use carefully when handling memory cards. Avoid liquids, dust, and debris.
As a precaution, please power off the camera before inserting or removing the
card. Check manufacturer guidelines regarding use in acceptable temperature
ranges
If camera cannot record, please format the used microSD card via computer.
HDMI Connection
Firmware Update
For camera’s best performance, please use the latest firmware.
Camera firmware update status: red light blinks fast, and camera shuts off automatically when the update is finished.
Firmware file name: split-hc.bin.
PWM Remote Control
Here we take Flight Controller Speedy Bee-F7 for an example.
Connect RunCam Split-H to SpeedyBee F7V3 via the cables, with Power wire (red)
to 5V pad, GND wire (black) to GND pad, PWM wire (yellow) to M6 pad.
Steps to configure
-
Configure M6 at CLI mode
-
Connect to BetaFlight, and enter the CLI interface
-
Type in resource to proceed, and type the command as below
resource motor 6 none
resource pinio 2 B05
set pinio_ config = 129,129,1,1
set pinio_ box = 0,41 ,255,255
save
-
Navigate to the Modes tab at the BetaFlight, and find Mode USER2. Here takes AUX3 as an example to configure, and the range is 1900-2100.
-
Please choose your Model on the controller, then access to the MIXER interface and assign the channel to a switch.
-
Here we take Radiomaster TX12 as an example, assigning CH7 to SF position.
Specifications
Product | SPLIT-H |
---|---|
Sensor | SONY(5MP) |
Field of view | FOV 94° |
Resolution | 1080P@60FPS |
Video file format | MP4 |
HDMI output format | 1080P60HZ |
SD card max. capacity | 128G(U3 recommended) |
Power range | 5-20V |
Lens module size | 19*19mm |
Mounting hole spacing | 26.5mm*30.5mm |
PCB size | 32mm*37mm |
Working current | 540mA@5V/365mA@7.4V/225mA@12V |
Weight | 22g |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>