kogan estelle LED Moisture Protect Pro Hair Dryer User Manual

kogan estelle LED Moisture Protect Pro Hair Dryer

SAFETY & WARNINGS

WARNING: To avoid accidental injuries such as electric shock and fire caused by improper use, be sure to observe the following safety precautions!

• Read all instructions in this guide before using this product. Retain this guide for future reference. Do not skip, substitute or modify any steps or procedures in this guide, as doing so could result in personal injury or product damage.
• This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product in a safe way by the person responsible for their safety, and understand the hazards involved.
• Children should be supervised to ensure that they do not play with the appliance.
• If the power cord is damaged, cease use immediately and contact help.Kogan.com for support.
  • Do not remove this label. To avoid danger of electrocution, do not store or leave the hair dryer in a position where it might fall into a bath-tub, basin, or other vessel containing water, even when the hair dryer switch is in the off position.
  • Remove the plug from the socket-outlet when the hair dryer is not being used.
• WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
• The appliance must be fixed so that the hand-held part, when fully extended, is out of reach of persons taking a bath or shower.
• When using this appliance in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.
• For additional protection, the installation of a residual current device (RCD) having a rated residual operation current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Consult a licenced trade professional for advice.
• Do not block the air inlet or place the air inlet facing down during operation. Doing so may cause the heating wire to overheat and ignite.
• Do not immerse the hair dryer in water or any other liquids.
• Do not use the hair dryer in a humid environments.
• To avoid potential damage and electric shock, do not expose the hair dryer to water or operate it with wet hands.
• To prevent the risk of fire or explosion from a short circuit, avoid using the hair dryer near any flammable substances such as petrol, paint, thinners, spray, etc.
• Avoid wrapping the power cord around the main body of the product, as this can lead to the power cord breaking, and increase the risk of electric shock or fire due to a short circuit.
• Avoid storing the product in a highly humid environment to prevent the risk of electric shock or fire due to a short circuit.
• Keep the product out of the reach of children and infants.
• Do not attempt to repair, disassemble, or modify the product on your own, as this can lead to injury due to improper operation or fire hazards.
• During use, the air outlet and nozzle may become hot, do not touch it with your hands or it may cause burns.
• This product is not suitable for infants or young children.
• Always unplug the hair dryer from the outlet after using it.
• Do not unplug by hair dryer by pulling on the power cord, instead grasp the plug.
• Avoid forcefully pulling the power cord to prevent it from breaking, causing electric shock or fire due to short circuit.
• Use the hair dryer solely for its intended purpose of drying hair. Do not use it to dry shoes or articles of clothing.
• Ensure to use the hair dryer only with an electrical outlet that is compatible with its power rating of 220-240V~.
• Do not use universal plugs or voltage converters to avoid potential dangers.
• When storing the hair dryer, avoid wrapping the power cord around the main body of the product to prevent damaging the power cord, which can cause electric shock or fire due to a short circuit.
• If this product or its power cord shows any signs of damage cease use immediately and contact help.Kogan.com for support.

OVERVIEW

OPERATION

Plug the appliance to the electrical supply. Make sure it is set at the “OFF” position.

Turning the Hair Dryer On/Off / Airflow Control

• Slide the power/speed switch upwards to turn the hair dryer ON.
• The “I” position is low speed.
• The “II” position is high speed.
• Slide the power/speed switch down to the “O” position to turn the hair dryer OFF.
• After use, please unplug the plug promptly.

Temperature Settings

• Short press the temperature button to cycle through four modes: cold air, warm air, hot air and alternating cold and hot air.
• The temperature mode can be adjusted in both speed settings.
• Upon restarting, the hair dryer will automatically resume the temperature mode from the previous use.

Self-cleaning

• Press and hold the temperature button for 5 seconds to activate the self-cleaning function. The air inlet will automatically blow and clean the air filter for 5 seconds.
• Press the temperature button again to switch back to normal operating mode.

Display

Low speed temperature modes:

Note: Display will operate the same in high speed.

Attaching/Removing Accessories

• This product is equipped with magnetic accessories for easy attachment and removal.
• The accessories can be rotated 360°.
• Ensure the hair dryer is off when attaching or removing accessories.

Note: To avoid burns, do not adjust or remove the accessories during operation. Allow the accessories to cool down before handling.

Magnetic Nozzle Installation

• Align the nozzle with the magnetic interface to easily attach and install it.
• The nozzle can be rotated to any angle according to your needs and usage habits for convenient use.

Note

• Please install the nozzle when the device is turned off.
• Do not adjust or remove the nozzle during operation to avoid burns.

CLEANING & CARE

• Before cleaning, ensure that the power switch is turned off and hair dryer has been unplugged from the electrical outlet.
• Do not use any corrosive liquids such as alcohol, nail polish remover or detergent to clean this product. Doing so may damage this product or cause malfunction.

Cleaning the Filter

• Remove the filter cover by pulling it downwards.
• Use a dry lint-free cloth, cotton swab or soft brush to remove any dust, hair or debris from the filter cover and the stainless-steel mesh filter.
• Do not press or rub the stainless-steel air inlet filter with fingernails or sharp objects.
• After cleaning, install the filter cover back to its original position.
• Clean the filter at least once a month.
• Do not operate the hair dryer with the filter cover removed.

Note

• Do not wash the inlet filter mesh with water, as it may cause malfunctions.

Table of Hazardous Substances in the Product

The content of the table is prepared according to the provisions of SJ/T11364.

Component

| Harmful Substances
---|---

Lead (Pb)

|

Mercury (Hg)

| Cadmi um (Cd)| Hexavalent Chromium (Cr (VI))| Polybromin rated Biphenyls (PBB)| Polybrominated ted Diphenyl Ethers (PBDE)
Plastic Components| O| O| O| O| O| O
Metal Components| O| O| O| O| O| O
Heating

Element Components

|

O

|

O

|

O

|

O

|

O

|

O

Motor Components| O| O| O| O| O| O
Circuit Control Component|

X

|

O

|

O

|

O

|

O

|

O

Power Cord| O| O| O| O| O| O
Accessories| O| O| O| O| O| O

• O: Indicates that the content of harmful substances in all homogeneous materials of this component is below the “limit requirement” specified in the current effective version of GB/T26572.
• X: Indicates that the content of harmful substances in at least one homogeneous material of this component exceeds the limit requirement specified in the current effective version of GB/T26572.

SPECIFICATIONS

GB 4706.1-2005

 | GB 4706.15-2008

This marking indicates that this appliance should not be disposed with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.

TROUBLESHOOTING

Note: If following the steps below still does not resolve the issue and restore normal operation of the product, cease use immediately and contact help.Kogan.com for support.

help.Kogan.com
Abnormal display on the screen| Internal malfunction| Contact help.Kogan.com
Burning smell during operation| Internal components are damaged| Contact help.Kogan.com
No airflow or weak airflow| Air inlet is blocked| Clean the air inlet grille and air inlet filter
Product feels very hot, or air temperature is very high
The internal components turn red and emit smoke| Safety protection device is not functioning properly| Contact help.Kogan.com
Power cord or plug is overheating or deformed| The power cord is damaged| Contact help.Kogan.com

Need more information?

We hope that this user guide has given you the assistance needed for a simple set-up.
For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>