SIMIX Multi Surface Ceramic Clearcoat Instructions
- June 17, 2024
- SIMIX
Table of Contents
SIMIX Multi Surface Ceramic Clearcoat
How to Clean
How to Clean and Coat Air Conditioning Systems with SIMIX Multi-Surface Ceramic Clearcoat
Straighten fins. Optional step if minor damage.
-
Step 1: Turn off the unit and pull the breaker.
-
Step 2: Dissolve SIMIX Multi-Surface Peroxide Cleaner & Degreaser in a pump-up sprayer. You will use 1 big scoop of SIMIX powder for every 1 gallon of hot water if available. Shake to mix solution.
To Clean Unit -
Step 3: Soak the condensing and evaporator coils, fan, and cabinet with SIMIX cleaning solution inside/out and outside/in until you see the cleaner water mixture running off.
-
Step 4: Allow the cleaner to soak for 5 to 10 minutes.
-
Step 5: Thoroughly rinse from top to bottom, inside/out and outside/in.
-
Step 6: Repeat steps 1 through 3 if needed.
-
Step 7: Replace the breaker turn on and run the FAN ONLY to dry the evaporator coils. Prepare SIMIX Multi-Surface Ceramic Clearcoat. Refer to Mixing/Dilution charts (sheet) 4 parts water with 1 part coating in pump up sprayer. (use distilled or RO water)
Apply SIMIX Multi-Surface Ceramic Clearcoat
- Step 1: Turn off the unit and pull the breaker.
- Step 2: Spray the evaporator coil from inside/out, outside/in, and coat from both sides if possible. Spray until the fins are completely soaked and the coating is visibly running down the coils.
- Step 3: Replace the breaker and turn on FAN ONLY to dry and cure the coating (at least 15 minutes and dry to the touch).
- Step 4: Once evaporator coil is dry and cured, check the condensing coil to see if it is dry and ready for coating.
- Step 5: Once dry, turn off the breaker, coat the condensing coils, and go slowly enough to ensure SIMIX is going all the way through the fins.
- Step 6: Spray coating on everything else inside the unit including both sides of the fan.
- Step 7: Close the unit.
- Step 8: Spray coating on the entire cabinet exterior and buff dry with Microfiber cloth. Once done replace the breaker and turn the unit back on to cool.
- Step 9: Run for at least 20 minutes so the coating cures.
You will need
- (2) 2-4 gallon pump-up sprayers
- Electrostatic sprayer (optional for coating)
- Water supply hose
- Pressure washer with 40° fan tip (hot water unit if available) Fin comb (optional)
- SIMIX Multi-Surface Cleaner & Degreaser
- SIMIX Multi-Surface Ceramic Clearcoat
- Distilled or RO water
CONTACT
- SIMIX I KENOSHA,
- WISCONSIN I
- info@simixusa.com
- I simixusa.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>