elica PRF0166822 Built-in Hood Instruction Manual

: June 12, 2024
: ELICA

Table of Contents

Warnings and installation
GENERAL SAFETY
INSTALLATION SAFETY
ELECTRICAL CONNECTION SAFETY
MAINTENANCE WARNINGS
END-OF-LIFE DISPOSAL
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

elica PRF0166822 Built-in Hood Instruction Manual

Warnings and installation

The product is designed for the extraction of cooking fumes and steam and it is for domestic use only.

GENERAL SAFETY

Do not make electrical or mechanical changes on the product or on the exhaust pipes.
Before doing any cleaning or maintenance work, disconnect the product from the mains power supply by removing the plug or turning off the mains switch.
For all installation and maintenance operations, always wear work gloves.•
The product can be used by children over the age of 8 and by people with reduced physical, sensory or mental capabilities or without experience or the necessary knowledge, as long as they are properly supervised or have been instructed on how to safely use the device and understand the inherent dangers.•
Children must be supervised to make sure that they do not play with the product.•
Cleaning and maintenance must never be performed by children unless they are properly supervised.
The room must have sufficient ventilation when the product is used at the same time as other appliances burning gas or other fuels.
The product must be cleaned frequently both inside and out (AT LEAST ONCE A MONTH); always follow the instructions given in the maintenance manual.
Failure to comply with the rules indicated for cleaning the product and replacing/cleaning the filters may result in the risk of fire.•
It is strictly forbidden to cook food on the flame under the product.
WARNING:
When the hob is on, the accessible parts of the product may become hot.•
Do not connect the product to the electrical power supply until the installation is complete.•
The regulations laid down by local authorities must be strictly followed with regard to the technical and safety measures to adopt for fume extraction.•
The extracted air must not be conveyed through the same ducts used to extract the fumes generated by gas combustion or other types of combustion products.•
Do not use or leave the product without appropriately installed lamps, as this may result in the risk of electric shock.•
The product must NEVER be used without the grille correctly fitted.
The product must NEVER be used as a support surface unless expressly indicated.

INSTALLATION SAFETY

Use the fixing screws supplied with the product only if suitable for the surface; otherwise purchase the correct type of screws.
Check for accessories (e.g. bags containing screws, warranty certificates, etc.) inside the product (placed there for transport reasons). If there are any, remove them and keep them safe.
WARNING: Failure to install screws and fasteners in accordance with these instructions may result in electrical hazards.
The exhaust pipe is not supplied and must be purchased.
The diameter of the exhaust pipe must be equivalent to the diameter of the connecting ring. •For installation of the product on the hob, respect the height indicated in the drawings
The minimum distance between the surface of the container supports on the cooker and the lowest part of the range hood must not be less than 50 cm for electric cookers and 65 cm for gas or mixed cookers.
If the installation instructions of the gas cooker specify a greater distance, take it into account.

ELECTRICAL CONNECTION SAFETY

The mains voltage must correspond to the voltage indicated on the label found inside the product.
If it features a plug, connect the product to a socket that complies with current standards, located in an area accessible even after installation.
If it does not feature a plug (direct connection to the mains) or the plug is not located in an accessible area, even after installation, apply a standard double pole switch that ensures complete disconnection from the mains in category III overvoltage conditions, in accordance with the installation rules.
The product features a special power cable; if the cable is damaged, contact the Service Centre for a replacement.

MAINTENANCE WARNINGS

Cleaning : For cleaning, simply use a cloth moistened with neutral liquid detergents. Do not use cleaning tools or instruments.
Anti-Grease Filter : The metallic anti-grease filter must be cleaned once a month with non aggressive detergents, manually or in a dishwasher on a short wash at low temperatures. To remove the anti-grease filter, pull the spring release handle.
Carbon Filter (for filter version only) : It is necessary to replace the cartridge at least every four months. It CANNOT be washed or regenerated. As indicated in the drawings section: remove the anti-grease filters, apply a carbon filter on each side and attach it to the product. Put the anti-grease filters back in
Lamp Replacement : Disconnect the product from the electrical power supply. Please note! Before touching the lamps, make sure they have cooled. For the type of lamp to use, see the indications in the drawings section.

END-OF-LIFE DISPOSAL

This device is marked in compliance with the European Directive 2012/19/EC – UK SI 2013 No.3113, Waste Electrical and Electronic Equipment (WEEE). Make sure that this product is disposed of correctly. The user helps prevent potential negative consequences for the environment and for health. The symbol on the product or accompanying documentation indicates that this product should not be treated as household waste but should be handed over at a suitable collection point for the recycling of electrical and electronic equipment. Dispose of it in accordance with local regulations for waste disposal. For further information about the treatment, recovery and recycling of this product, please contact your local authority, the collection service for household waste or the shop from where the product was purchased.

REGULATIONS
Equipment designed, tested and manufactured in compliance with safety regulations: EN/IEC 60335-1; EN/IEC 60335-2- 31, EN/IEC 62233. Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13;EN/IEC 60704-3; ISO 3741; EN 50564; IEC 62301. EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3.

NOTES
: the parts marked with this symbol can be purchased separately from specialised dealers.
: the parts marked with this symbol are optional accessories supplied only with some models and can be purchased from the websites www.elica.com and www.shop.elica.com.

Warning Instruction
In/Out View
Package Contents
Dimension
Installation
Wiring Connection