nedis ANOR5002BK700 Digital Outdoor TV Antenna Instruction Manual
- June 16, 2024
- nedis
Table of Contents
DIGITAL OUTDOOR TV ANTENNA
ANOR5002BK700
Included in Package:
Before start your installation,please check the contents.
- Antenna main unit
- Wall /Pole mounting accessories
- AC/DC power adapter
- DC power insert
Operation Instruction:
Note: For the best reception, please check the following conditions
- Keep the antenna away from the sources of interference: keep the antenna away from those big power consumption devices, such as air conditioner, elevator, hair dryer and microwave oven…ect.
- Place the antenna near windows when use the antenna in indoor environment.
- Install the antenna as high as possible: in digital terrestrial reception, if there are some interceptions between antenna and transmission tower, it will cause the signal loss temporary. So if the antenna is installed as high as possible, those interceptions will be reduced.
Mounting the antenna:
This antenna can be used both indoor and outdoor, with the included mounting
accessories,it can be mounted on the wall or the pole.
(Fig.1) use the pole mounting accessories to fix the antenna on the pole.
(Fig.2) use the wall mounting accessories to fix the antenna on the wall
(Fig.3) connect the “F” male connector of the coaxial cable to the “F” female connector of the antenna, and wear the water-proof cap to the end of the connected “F” connector.
Note: After the antenna mounting is finished, please move the antenna to a best reception position and then fix it.
Please take reference of following 2 different positioning way to adjust the
antenna position.
(Fig.4) through the fixing screw A to adjust the antenna position in vertical
direction
(Fig.5) through the fixing screw B to adjust the antenna position left or
right in horizontal direction
Installation 1: Powered by DTV set-top box (Fig.6)
Please be noticed, in this installation, you need to make sure that your set-
top box can support coaxial cable 5V DC powering via the IEC or F connector to
antenna.
Step1.Connect the coaxial cable with antenna and DTV set-top box
Step2.Connect the DTV set-top box to your TV. Please make sure the coaxial
cable powering function of your STB is ON. (Please check
The operational manual of your STB for coaxial cable powering function)
Step3.Check the LED on the antenna. If the LED is not lighted on, please go
back to Step2.
Step4.Adjust the antenna in the best position that can get clear TV picture,
then fix the antenna
Step5.Organize the coaxial cable for neat, tidy and safety.
Installation 2: Powered by AC/DC adapter (Fig.7)
Step1. Connect the coaxial cable with antenna and the power insert (the side
with “antenna” text mark).
Setp2. Connect the other side of power insert to DTV set-top box.
Step3. Connect the DTV set-top box to your TV
Step4. Connect the power adapter DC output jack to the DC input connector of
the Power insert, and then plug the AC/DC power adapter into the AC power
socket.
Step5. Check the LED on the antenna. If the LED is not lighted on, please go
back to Step4.
Step6. Adjust the antenna in the best position that can get clear TV picture,
then fix the antenna
Step7. Organize the Coaxial Cable for neat, tidy and safety.
Contact
NEDIS B.V., De Tweeling 28, 5215 MC ‘s-Hertogenbosch, The Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>