Aerpro G4000 Inspection Camera User Manual
- June 16, 2024
- Aerpro
Table of Contents
Aerpro G4000 Inspection Camera
Introduction
Please read this manual carefully before using the Inspection Camera and follow the herein instructions to avoid damage caused by improper use.
Using your inspection camera
ON/OFF: Press and hold the button for 3 seconds
LED brightness adjustment: Press the button to adjust the LED illumination
level, until the maximum level is reached. Press again to turn it off.
ZOOM/ROTATE: Short press the button to enlarge the image on a screen. It will
enlarge the image 1.5 to 2 times. Long press the button for 3 seconds to
mirror the image
Battery installation
Open the battery compartment cover. Insert four AA batteries into the battery compartment. Make sure the polarity of the batteries is correct. Close the battery compartment cover to secure it.
Inclusions
Accessories Installation
- First, place the single hook or mirror into the hole on the lens as indicated by the arrow, and then push the attachment fixture.
- 2. Insert the magnet into the attachment fixture, with the pointed end placed into the hole on the lens as indicated by the arrow, and then tighten the attachment fixture to secure it as shown.
Specifications
| Camera Lens Diameter | 5.5mm |
|---|---|
| Snake Tube Length | 1 metre |
| Pixels | 640 X 480 |
| Screen Size | 2.4″ TFT LCD |
| Field Of View | 50° |
| Waterproof Level | IP 67 |
| Sensor | 1/10″ CMOS |
| Manual Dimming | Support |
| Enlarge/Mirror | Support |
| Snake Tube Material | Flexible Metal Tube |
| Battery Type | 4 x AA Batteries (not included) |
If you need assistance setting up or using your Aerpro product now or in the future, call Aerpro Support Australia
TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9 am – 5 pm AEST This
manual is considered correct at the time of printing but is subject to change.
For the latest manuals and updates refer to the website.
AERPRO.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>