nedis HDDUDB3210BK Dual Bay HDD Docking Station User Guide
- June 16, 2024
- nedis
Table of Contents
nedis HDDUDB3210BK Dual Bay HDD Docking Station User Guide
Dual Bay HDD Docking Station
For more information see the extended manual online: ned.is/hddudb3210bk
Intended use
This product is a docking station for easy plug and play connection and cloning of up to two external hard disk drives or solid state drives.
The product is intended for indoor use only.
Any modification of the product may have consequences for safety, warranty and proper functioning.
Main parts (image A)
- Hard disk slot 1
- Hard disk slot 2
- Power switch
- USB Type-B port
- Clone button
- Power input
- USB Type-A – Type-B cable
- Power cable
- HDD1 indicator LED
- Cloning progress indicator LEDs
- HDD2 indicator LED
- Power indicator LED
Safety instructions
WARNING
- Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
- Only use the product as described in this document.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
- Do not drop the product and avoid bumping.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Do not expose the product to water or moisture.
Using the product
- Place the product on a flat, stable surface.
- Make sure there is a recent backup of your hard disk before using this product.
- Insert a 2.5 or 3.5 ich HDD hard disk (not included) into one of the hard disk slots A12.
- Plug the power cable A8 into the power input A6.
- Plug the other end of the power cable A8 into a power outlet.
- Plug the USB Type-B cable A7 into the USB Type-B port A4.
- Plug the other end of the USB Type-B cable A7 into your computer.
- Switch the power switch A3 to I.
The power indicator LED Ae lights up.
Cloning a hard drive
-
Plug the power cable A8 into the power input A6.
-
The power indicator LED Ae lights up.
-
Insert the source hard disk into hard disk slot 1 A1.
The HDD2 indicator LED Aw lights up. -
Insert the target hard disk into hard disk slot 2 A2.
The HDD1 indicator LED A9 lights up. -
Press and hold the Clone button A5 for 5 seconds.
The Cloning progress indicator LEDs Aq starts to flash.
The contents of the source hard disk will be copied to the target hard disk. -
The Cloning progress indicator LEDs Aq show the copy progress. When the copy is done, all Cloning progress indicator LEDs Aq light up
Disposal
The product is designated for
separate collection at an appropriate collection point. Do not dispose of the
product with household waste.
For more information, contact the retailer or the local authority responsible for the waste management.