Ciro G0016000 Deflex Heat Shields Instructions
- June 16, 2024
- Ciro
Table of Contents
Deflex heat shields for indian chieftain
G0016000 Deflex Heat Shields
WARNING
This indication alerts you to the fact that ignoring the contents described
herein can result in potential serious injury or death if not followed.
CAUTION
This indication alerts you to the fact that ignoring the contents described
herein can or will result in material damage and/or personal injury.
ATTENTION
This indication alerts you to the fact if you ignore this detail you will
affect the performance or functionality of the product.
All Ciro products are designed for “easy assembly” and/or “plug and play”. We
recommend a competent mechanic install our products, using standard mechanical
procedures to assure a safe and successful installation. Read completely and
understand the instructions prior to starting installation.
NOTE: Ciro products are designed and manufactured under very strict
quality control. Ciro warrants that products sold to the original purchaser
shall be free from any defects in materials and workmanship for a period of 3
(three) years from the date of purchase, and a limited lifetime warranty
against LED failure. Ciro will have no obligation if the customer cannot show
proof of purchase. Warranty will not be granted unless the part is properly
installed, unmodified and maintained. Ciro will not be liable for any
consequential and incidental damages, including labor, or non-Ciro products.
Please visit Ciro3d.com for our complete warranty policy.
Included Parts
Installation Instructions:
- Park on a level surface and shut off the motorcyle. Ensure that the engine has time to cool before installation.
- Clean area on side cover with an ammonia based cleaner to thoroughly remove any wax, dirt, or other factory coatings. Fig. 1
- Dry fit Deflex Heat Shields to understand correct position. There should be approximately 1/2” clearance between the top edge and the fuel tank. Fig. 2 The side should follow the body line on the side cover as shown in Fig. 3.
- Remove backing tape and adhere to side cover. Press firmly for 30-60 seconds. Fig. 4
- Adhesive is rideable in one hour and cures fully in 24 hours.
G0016000, REV.-
For the latest version of installation instructions visit
www.ciro3d.com
Ciro3d.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>