Bracwiser ML71201 Single 47 Tall Fully Adjustable Monitor Arm Stand Mount Instruction Manual

June 16, 2024
Bracwiser

Bracwiser ML71201 Single 47 Tall Fully Adjustable Monitor Arm Stand Mount Instruction Manual
Bracwiser ML71201 Single 47 Tall Fully Adjustable Monitor Arm Stand
Mount

Unboxing Instruction

Please open the box carefully and take off protection such as lining and covers.
Check all parts make sure all components and parts are not damaged.
Do not use damaged components or parts. Read this manual before installation.

Important Safety Information

Please be careful during installation and operation. Read this manual before installation, Follow the manual and use tools as advised in the package.
Installation need to be completed by professional or under others help.
Do not disassemble any components if there is no instruction in the manual. We are not responsible for any loss due to incorrect installation or incorrect use of this item.

Parts

  • (3)pole-a

  • (1) upper base-b

    1. lower base-c
  • (1) head sleeve-d

  • 1)VESA plate-e

  • (3)M5×18-f
    Parts

  • (3) wire clip-g

  • (1) homemade wrench-h

  • (1)S3/S4/S5 wrench-i

  • (2)supporting leg-j

  • (4)M4x30-G1

  • (4)M4x12-G2

  • (4)Spacer-H1

  • (4)Spacer-H2

  • (4)04 Washer-F

CAUTION!

WARNING

This monitor stand must be at a horizontal platform. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.

Step 1 Installation of Pole and Base

Base installation

Loosen pre-positioned screws in the base with wrench (i), get upper base (b) and lower base (c). Align supporting leg (j) with upper base (b) and lower base (c), tighten screws with wrench (i).
Base installation

Connect base and pole

Connect base and pole(a) with 3 pieces of M5x18 screws (f) and tighten with wrench (i).

Tighten and splice two poles into one, then tighten the stud with wrench to secure.
Base installation

Step 2 Connect Head Sleeve and Pole

  1. Place wire clip (g) on pole (a).
  2. Place head sleeve (d) on pole (a). Tighten with wrench (i) at proper position.
    Sleeve and Pole

Step 3 Connect VESA Plate and Monitor

Plate and Monitor

Step 4 Connect Monitor and Mount

Insert monitor into head sleeve
Monitor and Mount

Insert screw of plate into screw hole of head sleeve
Monitor and Mount

Step 5 Angle Adjustment of Head Sleeve

Adjust head sleeve according to the needs in case of sagging of monitor.

Head Sleeve

To adjust height of monitor, tighten or loosen the screw, fix plate by tightening nut at proper position,
Installation

Step 6 Cable Management

Cable Management

Manage cables in wire clip (g).
we hope you never have the need, but if you do,our service is friendly and hassle-free.
:after-sales@bracketwiser.com

Company Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals