Bracwiser MD7442 Dual Fully Adjustable Monitor Arm Stand Mount Instruction Manual

Bracwiser MD7442 Dual Fully Adjustable Monitor Arm Stand Mount

Unboxing Instruction

• Please open the box carefully and take off protection such as lining and covers.
• Check all parts make sure all components and parts are not damaged. Do not use damaged components or parts.
• Read this manual before installation.

Important Safety Information

• Please be careful during installation and operation. Read this manual before installation. Follow the manual and use tools as advised in the package.
• Installation need to be completed by professional or under others help. Do not disassemble any components if there is no instruction in the manual. We are not responsible for any loss due to incorrect installation or incorrect use of this item.

PARTS

CAUTION!

• This monitor desktop mount must be securely attached to the horizontal desk. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.

Step 1 Install the Pole on a Desk

Option A : Clamp installation

1. Connect clamp support (c) and pole (a) with 3 pieces of M5x18 (f) and tighten it with wrench (i) (figure 1).
2. Connect clamp (b) and clamp support (c) with pre-positioned screws and choose proper hole sit according to the thickness of desk (figure 2). Tighten the plastic knob to fix the clamp (figure 3)

Option B: Grommet installation

1. Connect grommet support (c) and pole (a) with 3 pieces of M5x18 (f) and tighten it with wrench (i) (figure 1). Insert grommet support (c) into desk hole whose diameter is over 1.65in/42mm (figure 2).
2.  Connect grommet (b) and grommet support (c) with pre-positioned screws and choose proper hole site according to the thickness of desk (figure 3). Tighten the plastic knob to fix the clamp (figure 4).

Step 2 Connect Swivel Arm and Pole

1. Place pole wire clip (g) on the pole (a).
2. Place arm wire clip (h) on the swivel arm (d)
3. Place swivel arm (d) on pole (a). Tighten with wrench (i) at proper position.

Step 3 Connect VESA Plate and Monitor

WARNING:
Make sure the screws are tightened.

Step 4 Connect Monitor and Mount

Step 5 Angle Adjustment of Head Sleeve

• Adjust the head of swivel arm according to the needs in case of sagging of monitor.

• To adjust height of monitor, tighten or loosen the screw, fix plate by tightening nut at proper position.

Step 6 Cable Management

• Manage cables with arm wire clip (h) and pole wire clip (g).
  • we hope you never have the need but if you do ,our service is friendly and hassle-free. : after-sales@bracketwiser.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>