Bracwiser ML7401 Single Fully Adjustable Monitor Arm Stand Mount Instruction Manual

Bracwiser ML7401 Single Fully Adjustable Monitor Arm Stand Mount

UNPACKING INSTRUCTIONS

• Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
• Check package contents against the Supplied Parts List in the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
• Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

• Install and operate this device with care. Please read this instruction before beginning the installation, and carefully follow all instructions contained herein. Use proper safely equipment during installation.
• Please call a qualified installation contractor for help if you:
• If you don’ t understand these directions or have any doubts about the safely of the installation.
• If you are uncertain about the nature of your wall, consult a qualified installation contractor.
• Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaims any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

PARTS

INSTALLATION INSTRUCTION

• Step 1 Install the Pole on a Desk

  • Base Installation
    Loosen pre-pationed screws in the base with wrench (i), get upper base (b) and lower base (c). Align supporting leg (i) with upper base (b) and lower base (c), tighten screws with wrench (i).

  • Connect base and pole
    Connect base and pole(a) with 3 pieces of M5x18 screws (f) and tighten with wrench (i).

• Step 2 Connect Head Sleeve and Pole

1. Place wire clip (g) on pole (a).
2. Place head sleeve (d) on pole (a). Tighten with wrench (i) at proper position.

• Step 3 Connect VESA Plate and Monitor
  WARNING:
  Make sure the screws are tightened.

• **Step 4 Connect Monitor and Mount

**

• Step 5 Angle Adjustment of Head Sleeve
  • Adjust head sleeve according to the needs in case of sagging of monitor.
  • To adjust height tigmen tor, loosen the nur seate position.

• Step 6 Cable Management
  Manage cables in wire clip (g)

AFTER SALES SUPPORT
after-sales-eu@bracketwiser.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>