Bracwiser MD7821 Single Fully Adjustable Standing Height Monitor Arm Stand Mount Instruction Manual
- June 15, 2024
- Bracwiser
Table of Contents
Bracwiser MD7821 Single Fully Adjustable Standing Height Monitor Arm
Stand Mount
Unboxing Instruction
- Please open the box carefully and take off protection such as lining and covers.
- Check all parts make sure all components and parts are not damaged.
- Do not use damaged components or parts.
- Read this manual before installation.
Important Safety Information
Please be careful during installation and operation. Read this manual before
installation. Follow the manual and use tools as advised in the package.
Installation need to be completed by professional or under others help. Do not
disassemble any components if there is no instruction in the manual. We are
not responsible for any loss due to incorrect installation or incorrect use of
this item.
Parts
CAUTION!
This monitor desktop mount must be securely attached to the horizontal desk.
If the mount is not properly installed it may fall, resulting in possible
injury and/or damage.
Step 1 Install the Pole on a Desk
Option A: Clamp installation
- Connect clamp support (c) and pole (a) with 3 pieces of M5x18 (f) and tighten it with wrench (i) (figure 1).
- Connect clamp (b) and clamp support (c) with pre-positioned screws and choose proper hole sit according to the thickness of desk (figure 2). Tighten the plastic knob to fix the clamp (figure 3)
Option B: Grommet installation
- Connect grommet support (c) and pole (a) with 3 pieces of M5x18 (f) and tighten it with wrench (i) (figure 1). Insert grommet support (c) into desk hole whose diameter is over l.65in/42mm (figure 2).
- Connect grommet (b) and grommet support (c) with pre-positioned screws and choose proper hole site according to the thickness of desk (figure 3). Tighten the plastic knob to fix the clamp (figure 4).
Step 2 Connect Swivel Arm and Pole
1. Place pole wire clip (g) on the pole (a).
2. Place arm wire clip (h) on the swivel arm (d).
3. Place swivel arm (d) on pole (a). Tighten with wrench (i) at proper
position.
Step 3 Connect VESA Plate and Monitor
Step 4 Connect Monitor and Mount
Step 5 Angle Adjustment of Head Sleeve
Step 6 Cable Management
Make adjustment with wrench (i). Manage cables with arm wire clip (h) and pole wire clip (g).
we hope you never have the need,but if you do,our service is friendly and
hassle-free.
after-sales@bracketwiser.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>