Bracwiser MD71221 Monitor Mount Single Fully Adjustable Arm Installation Guide
- June 15, 2024
- Bracwiser
Table of Contents
MD71221 Monitor Mount Single Fully Adjustable Arm
Installation Guide
**INSTALAMD71221
**
MD71221 Monitor Mount Single Fully Adjustable Arm
Unboxing Instruction
Please open the box carefully and take off protection such as lining and
covers.
Check all parts make sure all components and parts are not damaged.
Do not use damaged components or parts.
Read this manual before installation.
Important Safety Information
Please be careful during installation and operation. Read this manual before
installation. Follow the manual and use tools as advised in the package.
Installation need to be completed by professional or under others help.
Do not disassemble any components if there is no instruction in the manual. We
are not
responsible for any loss due to incorrect installation or incorrect use of
this item.
Parts
CAUTION
WARNING
This monitor desktop mount must be securely attached to the horizontal
desk. If the mount is not properly installed it may fall, resulting in
possible injury and/or damage.
Install the Pole on a Desk
Option A: Clamp installation
- Connect clamp support (c) and pole (a) with 3 pieces of M5x18 (f) and tighten it with wrench (i) (figure 1).
- Connect clamp (b) and clamp support (c) with pre-positioned screws and choose proper hole sit according to the thickness of desk (figure 2). Tighten the plastic knob to fix the clamp (figure 3)
Option B: Grommet installation
- Connect grommet support (c) and pole (a) with 3 pieces of M5x18 (f) and tighten it with wrench (i) (figure 1). Insert grommet support (c) into desk hole whose diameter is over 1.65in/42mm (figure 2).
- Connect grommet (b) and grommet support (c) with pre-positioned screws and choose proper hole site according to the thickness of desk (figure 3). Tighten the plastic knob to fix the clamp (figure 4).
Connect Swivel Arm and Pole
- Place pole wire clip (g) on the pole (a).
- Place arm wire clip (h) on the swivel arm (d).
- Place swivel arm (d) on pole (a). Tighten with wrench (i) at proper position.
Connect VESA Plate and Monitor
WARNING : Make sure the screws are tightened.
Connect Monitor and Mount
Insert monitor into the head of swivel arm
Drive screw pre- positioned in plate into screw hole in head of swivel arm
Angle Adjustment of Head Sleeve
Adjust the head of swivel arm according to the needs in case of sagging of monitor.
To adjust height of monitor, tighten or loosen the screw, fix plate by tightening nut at proper position.
Cable Management
Make adjustment with wrench (i). Manage cables with arm wire clip (h) and pole
wire clip (g).
we hope you never have the need,but if you do,our service is friendly and
hassle-free.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>