Aerpro CHNI3C Steering Wheel Control Interface Instruction Manual
- June 16, 2024
- Aerpro
Table of Contents
Aerpro CHNI3C Steering Wheel Control Interface Instruction Manual
ABOUT THIS PRODUCT…
CHNI3C
Nissan steering wheel control interface for Nissan vehicles without CAN-Bus.
Product Contents
- Interface
- Harness
- Instruction
Application
Navara 2006> 350Z 2003> X-Trail 2001>
6 & 10 Way Nissan Connector
- Interface
- Male Power/Speaker ISO connector
- Vehicle specific connector/s
Prior to installation
Read the manual prior to installation. Technical knowledge isnecessary for
installation. The place of installation must be free of moisture and away from
heat sources. Please ensure you use the correct toolsto avoid damage to the
vehicle or product.
Aerpro can not be held responsible for the installation of this product.
Technical Support
If you need assistance setting up or using your Aerpro product now or in the future, call Aerpro Support Australia TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST. If you would like to download a digital copy of this manual, or other Aerpro manuals/software, please visit the http://aerpro.com website.
FITTING GUIDE
-
Remove and disconnect the original head unit.
-
Connect the 12 way molex connector of the head unit patch lead (supplied separately) to the interface.
-
Connect the opposite end of head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit. Thismay be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect. Important Note: This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function.
-
Connect the 14 way molex connector to the interface.
-
Connect the male power/speaker ISO harnessto the female power/speaker ISO harness from the aftermarket head unit.
For aftermarket head units which do not have an ISO connector the interface uses the following wiring colours:
| Wire Colour | Function |
|---|---|
| Yellow | Permanent 12V |
| Black | Ground |
| Red | 12V Ignition |
| Orange | Illumination |
| Blue | Antenna Remote |
| Purple | Right Rear Speaker + |
| --- | --- |
| Purple/Black | Righ Rear Speaker – |
| Green | Left Rear Speaker + |
| Green/Black | Left Rear Speaker – |
| Grey | Right Front Speaker + |
| Grey/Black | Right Front Speaker – |
| White | Left Front Speaker + |
| White/Black | Left Front Speaker – |
- Connect the female vehicle specific connector to the male vehicle connector. Test head unit for correct operation.
STEERING WHEEL CONTROL FUNCTIONS
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>