SFA Sanipump Water Pump Installation Guide
- June 16, 2024
- SFA
Table of Contents
SFA Sanipump Water Pump
Sanivite Sanipump 2
Specifications
- Model: Sanivite Sanipump 2
- Standard: EN12050-2
- Voltage: 220-240V
- Frequency: 50Hz
- Power: 400W
- Current: 1.7A
- Protection Rating: IP44
- Weight: 6.4 kg
Product Usage Instructions
Installation
- Identify the designated location for the Sanivite Sanipump 2 installation.
- Ensure there is a suitable power outlet near the installation location.
- Connect the Sanivite Sanipump 2 to the existing plumbing system using the provided connectors (A, B, C, D, E, F, G, H).
- Securely fasten the connectors to ensure proper water flow.
- Ensure that the Sanivite Sanipump 2 is placed at a proper height for optimal performance (above 17 cm).
- If required, connect additional appliances to the Sanivite Sanipump 2 using the compatible connectors.
- Check all connections for leaks and make necessary adjustments.
Operation
The Sanivite Sanipump 2 is designed to pump wastewater away from various
fixtures in your home. Follow these steps to operate the product:
- Ensure that the Sanivite Sanipump 2 is connected to a power source.
- Turn on the power switch located on the Sanivite Sanipump 2.
- Use the fixtures connected to the Sanivite Sanipump 2 as usual (e.g., sink, dishwasher, washing machine).
- The Sanivite Sanipump 2 will automatically pump the wastewater away.
- Monitor the product’s performance and check for any unusual noises or issues.
- In case of a power outage, the Sanivite Sanipump 2 will not operate until power is restored.
FAQ
-
Q: What is the maximum distance the Sanivite Sanipump 2 can pump wastewater?
A: The maximum distance depends on the height difference between the Sanivite Sanipump 2 and the outlet point. The product can pump wastewater up to 50 meters horizontally or up to 4 metersvertically. -
Q: Can I connect multiple appliances to the Sanivite Sanipump 2?
A: Yes, you can connect multiple appliances to the Sanivite Sanipump 2 using the provided connectors. Ensure that allconnections are securely fastened. -
Q: What should I do if there is a leak in the connections?
A: If you notice a leak in any of the connections, turn off the power to the Sanivite Sanipump 2 and check for any loose or damaged parts. Tighten or replace any faulty connectors to resolve theissue.
Sanivite Sanipump 2
INSTALLATION INSTRUCTIONS
Instruction
Tools
Assembly
Overview
Dimension
SERVICE HELPLINES
France
- Tel. 01 44 82 25 55
- Fax. 03 44 94 46 19
- Service information : www.sfa.biz