Handi Quilter HG01412 Lift Table Drawer Instruction Manual
- June 12, 2024
- Handi Quilter
Table of Contents
Lift Table Drawer
(HG01412)
Assembly Instructions
01/24/23
Parts List
HG-01412 Lift Table Drawer Contents
| PART # | DESCRIPTION | QTY |
|---|---|---|
| HG01412-0101 | SD DRAWER PAN ASSEMBLY W/SLIDES ATTACHED | 1 |
| HG01412-02 | BRACKET-LIFT SIDE MOUNT LEFT | 1 |
| HG01412-03 | BRACKET-LIFT SIDE MOUNT RIGHT | 1 |
| HG01412-04 | SD LIFT FRONT FACE | 1 |
| QM10724 | SCREW-#10-24 X 1.375 PHP | 4 |
| QM10717 | WASHER-#10 0.688” OD | 4 |
| QM10348 | SCREW-M3.5 X 8 PHP W ZN | 4 |
| QM10381 | SCREW-M3.5 X 12 PHP W ZN | 4 |
Tools Needed:
-
2 Phillips Screwdriver – not provided
- If desired drill for pre-drilling holes in top – not provided
- If desired 3/32” bit for drilling holes in top – not provided
- If desired small square to check brackets – not provided
Drawer Assembly
-
With the help of a second person carefully unplug the cables to the machine and remove it from the table.
-
Place the drawer front face on a protective surface with the pre-drilled holes facing up.
-
Place the pan onto the drawer face aligning the four pre-drilled holes and fasten it with four M3.5 X 8 wood screws using a #2 Phillips screwdriver.
Drawer Assembly – Continued -
Locate the Bracket-Lift Side Mount Left and Bracket-Lift Side Mount Right. (They are mirror images of each other)
NOTE: The drawer will be mounted on the opposite side from the table lift control switch.
NOTE: Screw heads go from outside of drawer towards inside of drawer
IMPORTANT: If you have a table extension on the side where you want the
drawer, the two front table extension screws will need to be removed along
with the nut backing plate behind the wood table spacer. The drawer bracket
will now be the nut backing plate for the screws. With someone helping support
the table extension momentarily, loosen the two front screws, slide out the
backing plate, slide the drawer bracket into place and tighten the two screws
into the drawer bracket.
-
Start with the outside bracket. Place a washer onto two screws and insert them through the two predrilled holes in the wooden table spacer and then into the threaded holes in the metal bracket. Start the screws by hand and then tighten them firmly with a #2 Phillips screwdriver.
-
Repeat the process from the previous Step for the inside bracket.
-
Check that each bracket is straight front to back and perpendicular to the front table edge. A combination square or small square might help with this.
-
Place the drawer pan assembly into the track by lifting the front of the drawer slightly and aligning it with the two brackets while sliding it in.
-
Check the drawer a few times by sliding the drawer in and out to ensure it moves smoothly.
-
Screw two M3.5 X 12 wood screws into the table top at the front of the bracket.
Note: This may be easier after carefully drilling a 3/32’” pilot hole. Be careful not to drill through the table top. -
Repeat the previous Step for the front of the other bracket.
Lift Table Drawer Installation Instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>