GIANNI PBA-600LD LED Illuminated Micro Switch Bar Instruction Manual
- June 16, 2024
- GIANNI
Table of Contents
**GIANNI PBA-600LD LED Illuminated Micro Switch Bar Instruction Manual
**
The PBA-600LD & PBA-860LD Micro Switch Bar is designed for emergency exit doors and other large-scale out swing doors. When the bar is depressed, or if access is granted by control device, the micro switch is activated to release the door. The dual-colour LED illumination design also allows people to locate the push bar in the dark quickly and easily.
The PBA-600LD & PBA-860LD features additional terminals including dry or wet input (from control device such as keypad or reader to change status of the LED illumination), a REX output (dry contact for direct control of electric locks) and LED indicator setting.
| Models | PBA-600LD | PBA-860LD |
|---|---|---|
| Dimensions | 600(L)x66(W)x61.5mm(D) | 875(L)x66(W)x61.5mm(D) |
| Current Draw | Activated 150mA/12VDC; Standby 25mA/12VDC Activated 350mA/24VDC; |
Standby 40mA/24VDC
Wet Contact Input Voltage| 12/24VDC
Relay Rating| 5A/125VAC
Finish| Clear anodized
Operating Voltage| 12/24VDC
LED Illumination| Green & Red
Dimensions
Wiring Diagrams
Caution:
Please ensure the dry (PB,GND) or wet (GND, NO+) contacts are connected
correctly. Passing voltage through dry contacts will cause the PCB to burnout
and this will not be covered by the warranty.
CAUTION
Incorrect wiring of dry or wet contacts will cause the PCB to burnout.
PBA-860LD Terminals
LED Input (Dry Contact)
LED Input (Wet Contact)
REX Output (Dry Contact)
Power Input (12/24 VDC)
PBA-860LD to directly control fail-safe locks.
PBA-860LD to directly control fail-secure locks.
Connect to the push button terminal of the digital keypad or proximity reader.
Using the output from digital keypad/proximity readerto control PBA-860LD (Wet Contact).
Using the output from digital keypad/proximity reader to control PBA-860LD (Dry Contact).
LED Indicator Setting
This setting indicates the LED is RED when on standby and will switch to Green when thebar is depressed.
This setting indicates the LED is GREEN when on standby and will switch to Red when the bar is depressed.
Place the jumper across the pins horizontally, not vertically
Copyright © All Rights Reserved. P-MU-PBA-860LD Published: 2023.06.08
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>