MVP GROUP KGG-36 Open Air Merchandiser Owner’s Manual
- June 15, 2024
- MVP GROUP
Table of Contents
OPEN AIR MERCHANDISER
KGG-36, KOM – 36 – 48 SS
Thank you for choosing and purchasing our product. Please carefully read the operation instructions before use.
General
This product is a new chilling cabinet which adds to our extensive refrigeration product lines. These units are primarily designed for beverages, dairy products , vegetables and fruits.
Structure and Parts
| Parameter | KGG-36 | KOM-36 SS |
|---|---|---|
| Coolant and injection quantity(g) | R-404a | R-404a |
| General Rated input power(W) | 1260 | 1260 |
| Power running(rating) of electrical heating element(W) | 450-536 | 450-536 |
| Max.ambient temp./RH | <27º C (80.6ºF) /70% | <27º C (80.6ºF) /70% |
| Refrigeration Temperature( ºC) | 1º – 4º | 1º – 4º |
| Rated voltage(V) | 115 | 115 |
| Rated frequency(Hz) | 60 | 60 |
| Rated current(A) | 11.6 | 11.6 |
| Foaming agent | C5H10 | C5H10 |
| Lamp power(W) | 2.8*2(LED | 2.8*2(LED ) |
| Total effective volume(L) | 320 | 320 |
| Overall dimension(inch) (LxWxH) | 36.2 x 33.3 x 59.4 | 36.1 x 31.2 x 57.4 |
Handling and Safety
Handle with care
Unplug the wall socket first.
Never tilt the unit over 45 degrees during handling.
Dry place
Always place the refrigerator in a dry place.
Sufficient space
There must be a min 10 cm clearance around all sides of the unit.
Well ventilation (ventilated)
Always locate the refrigerator in a well ventilated area. The first time you
use the unit, wait 2 hours after handling the unit before plugging it in.
After handling the or moving the unit, wait 2 hours before plugging the unit
in to allow the compressor to stabilize
Far from heat source
Never place the refrigerator directly in the sunlight. Never put the
refrigerator near any heat source or heater as this will reduce the
refrigerators capability.
No heavy load
Never put any heavy items on top of the refrigerator.
No hole making
Never make holes in the refrigerator.
Stable location
Unpack and locate the refrigerator on a flat, solid surface.
ADDITIONAL WARNINGS:
Caution: risk of fire. The height of the triangle in the symbol must be at
least 15mm.
Do not dispose of electrical appliances as unsorted municipal waste,use a
separate collection facilities. Contact you local government for information
regarding the correct way to dispose.
Preparation and Power Supply
Exclusive power socket
The power supply should be in a 115/60 single phase AC with exclusive single
phase three pin receptacle.
Must be on a dedicated circuit
Refrigerator needs to be on a dedicated circuit.
Protect cables
Never break or damage the cables. Replace any damaged, frayed or cut cables.
Do not spray water in the unit
Never spray the unit directly with water.
Keep away from flammables and explosives.
Never put any flammable or explosives inside the refrigerator (such as ether,
gasoline, alcohol, adhesive or explosive). Never put any dangerous products
near the refrigerator.
Do not spray unit with flammables
Do not spray the unit with flammables such as aerosols or cleaning products
near the refrigerator.
After a power outage
After a power outage unplug the refrigerator and wait at least 5 minutes
before plugging in and restarting the refrigerator
No medicine
Medicines should not be stored inside the refrigerator.
Use and Caution
-
Before use:
Plug the refrigerator in a dedicated outlet designed for the power rating of the unit..
This appliance is not intended for use by unauthorized individuals as well as individuals with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. -
Digital Temperature controller
Front Panel Operation
1. Set temperature
Press the set button, the default temperature that is currently set at will be displayed.
Press or button to modify and store the modified value.
Press the set button, this will save the new temperature
If for 10 seconds there is no response, the temperature will revert back to the default settings.
2. Lights: Press button, if the lights turn on ; Press again, and they will turn off.
Manually start/stop the defrost :Press button and hold for 6 seconds to start the defrost or stop the defrost.
3. Defrost LED: As the unit is cooling, the LED will stay on. When the temperature of the unit is at the set temperature the LED will be off. If there is a delay in the start then the LED will flash.
Maintenance
-
The product needs to be cleaned once a week with the power supply disconnected. While cleaning please use a mild rinsing water or non-corrosive detergent. Do not wash it directly with water.
-
Cleaning for filter
To keep the device in good working condition, the condenser needs to be cleaned every month.
When the message “EE4” appears on the display, please clean the condenser immediately.
After cleaning, if message “EE4” appearing again, please contact service. -
Check if the unit is leaking. Observe all the connectors and welding joints for any oil stains. If there are any oil stains call service.
-
Frequently observe the operation of the product. In case of any abnormal noise, smell or smoke, cut off the power supply immediately and call for service . Do not restart the product before the issue has been rectified.
-
MVP Group will not be liable for any accident incurred or failures that occurs due to actions that do not follow the guidelines indicated in the manuals.
Troubleshooting
| Causes| Solutions
---|---|---
Strange noise under the bottom shelf| Fan blade broken| Call
Service, the fan blade needs to be replaced.
Unit is not getting cold.| 1. Unit is off.
2. Refrigerant leaking
3. Unit has failure| Call Service
Defrost Water overflowing| 1. Heating tube is damaged
2. Water-level controller failure
3. Ambient temperature or humidity is above the recommeded settings.|
1. Replace the heating tube
2. Replace the water-level controller
3. Improve the conditions
Normal air curtain, but periodical fluctuation of cabinet temperature|
1. Condenser contaminated
2. Poor venting of the unit
3. Heat protection of compressor failure
4. Capillary is blocked by ice
5. Temperature controller failure| 1. Clean the condenser
2. Improve the venting conditions
3. Replace the heat protection
4. Replace the filter
5. Replace the temperature controller
Note
The murmur of water is heard when the refrigerator is working. It is a normal
occurrence as the coolant is circulating in the system.
Condensation might be found on the outside of the refrigerator. This is caused
by high humidity. Simply use a cloth to wipe it.
Circuit Diagram
3560 NW 56th Street
Fort Lauderdale, FL 33309
Tel.: 786.600.4687 / Toll Free: 844.218.8477
Fax.: 786.661.4100
5659 Royalmount Avenue
Montreal, Qc, Canada H4P 2P9
Tel.: 514.737.9701 / Toll Free: 888.275.4538
Fax.: 514.342.3854 / Toll Free: 877.453.8832
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>