Jmtek Industries WPC15 Magnetic Wireless Charger Instruction Manual
- June 6, 2024
- Jmtek Industries
Table of Contents
Magnetic Wireless Charger Instruction Manual
Please read the following carefully before using the device to ensure safe and proper use.
Package Content
- Wireless Charger
- USB-C to USB-C Fast Charging Cable
- User Manual
Specifications
- Input: DC 5V,2A/ DC 9V,2A
- Output: 5W/7.5W/10W/15W
- Auto-magnetic alignment for Phones with magnets underneath
- Charging Distance≤6mm
General information
- This charger works with all Qi-compatible devices (please make sure your device is Qi-compatible)
- For normal operation, no weaker than DC 5V, 2A adapter is required.
- For fast wireless charging mode, use the QC 2.0/QC 3.0 or PD adapter and compatible smartphones.
- This wireless charger can charge smartphones with non-metal protective case or silicone covers that are no thicker than 6mm.
Instructions
Connect the charging cable (included) to a USB-C charger, the Type -C plug to
the Type-C input of the wireless charger. Placee your Qi compatible phon with
inductive (wireless) charge feature onto charger (back of phone to charger),
then wireless charging of the phone will start immediately.
The magnetic wireless charger makes wireless charging a snap, perfectly
aligning the charging coil in the magnetic charger with the charging coil in
the iPhone 12 series. Please note: older iPhones have the same wireless
charging coil, but no magnets underneath to allow for magnetic connections.
Caution: Do not drop, disassemble or modify this product. Do not expose
this product to fire or excessive heat. Do not expose this product to water or
excessive humidity. Do not put any bare metal on the surface area of the
wireless charger when it is operating.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>