Silonn SLIM01S Portable Autmatic Ice Maker Instruction Manual
- June 15, 2024
- Silonn
Table of Contents
Silonn SLIM01S Portable Automatic Ice Maker
IMPORTANT SAFETY INFORMATION
To reduce the risk, follow these basic safety precautions.
WARNING
- Before using check that the voltage power corresponds to the one shown on the appliance nameplate.
- This appliance must be grounded.
- Avoid the use of an extension cord because it may overheat and cause a risk of fire. However, if it is necessary to use an extension cord:
- Use only an extension cord with a grounding plug.
- The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
- Do not operate if any component, including the cord or plug, is damaged.
- Unplug the unit before cleaning by hand and when not in use.
- Children or mentally/physically unable personnel are not allowed to operate the ice maker.
- Do not place the power cord in such a way it could be pulled on by children or cause a tripping hazard.
- Closely watch children who are near the unit when making ice.
- Do not use water that is micro-biologically unsafe or of un- unknown quality.
- Do not remove any safety, warning, or product information labels from the unit.
- Do not touch the evaporator with your hands while the ice maker is operating.
- Do not plug or unplug the unit with wet hands.
- The unit must be properly installed and located following the installation instructions before it is used. The unit is for indoor household use only.
- Do not store or use flammable vapours or liquids near the unit.
- Do not immerse any part of the unit in water.
- Do not attempt to disassemble, repair, modify or replace any part of the ice maker without permission.
WARNING
FIRE OR EXPLOSION HAZARD Flammable Refrigerant This unit contains an isobutane
refrigerant, also known as R600a is a natural gas with high environmental
compatibility. However, it is also combustible. Adhere to the warnings below
to reduce the risk of injury or property damage.
- When handling, installing and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
- Disposal of the unit under Federal and Local Regulations. Contact your local authorities for environmentally safe disposal of your refrigerator.
- Keep ventilation openings in the unit enclosures or the built-in structure clear of obstruction.
- Do not place the unit near heat sources such as an oven.
- Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
- Do not place the unit in direct sunlight.
PRODUCT INTRODUCTION
- Large Viewing Window
- Ice Full Sensor
- Ice Shovel
- Maximum Water Fill Line
- Air Exhaust Fan
- Control Panel
- Drain Plug
- Ice Basket
- Ice Scoop
CONTROL PANEL INTRODUTION
| Key (with indicator light)| Function
---|---|---
|
ADD WATER
| The indicator light turns red when the water reservoir lacks water.
| ICE FULL| The indicator light turns red when the ice basket is
full.
| s| The indicator light turns green when small ice mode is selected.
| L| The indicator light turns green when large ice mode is selected.
|
ON/OFF CLEAN
| Short press the “ON/OFF/ CLEAN” button to turn on the ice maker and the
“POWER” indica- tor light turns green.
Short press the “ON/OFF/ CLEAN” button to turn off the ice maker and the
“POWER” indica- tor flashes in green.
When the ice maker in the status of “standby”, long-press the “ON/ OFF/CLEAN”
button for 5 sec- onds and the ice maker will turn to self-cleaning mode, the
indica- tor lights of “S” and “L” will flash in green consecutively.
|
SELECT
| Confirming large ice mode or small ice mode.
USING YOUR ICE MAKER
BEFORE FIRST USE
- Stand Upright for 24Hrs Check for AccessoriesIf Missing Contact Customer Service.
- Discard the first 4 cycles of ice Use in locations 10°C ~ 32°C Perfect Ice Shape.
- What Not To Do! Unstable base No other liquids (Drinking water only) Use in temp below.
HOW TO USE YOUR ICE MAKER
- Open the cover and remove the basket Pour water, do not exceed the “MAX” watermark Press the “ON/ OFF” button
- Press “Select” to choose the ice cube size Wait 6min-13min
- Ice is full and ready when the “Ice” indicator is on.
- When the “ADD WATER” indicator is red, add water and press “ON/OFF”
CLEANING AND MAINTENANCE
To keep your ice tasting fresh and the unit looking great, we recommend
cleaning the unit once per week.
MANUAL CLEANING
- A DO’s & DON’T’s while cleaning and maintaining
- Do not use organic solvent, boiled water, detergent, strong acid strong alkali etc. for cleaning.
- Please empty the water reservoir and dry it for storage if the unit is not used for a long time.
- When the unit is not to be used for a long duration, drain the water completely & dry the interior.
- Store in a well-vented area.
SELF-CLEANING (30-MINUTE PROCESS).
PRODUCT SPECIFICATIONS
| Model | SLIM0l S/SLIMOlR/SLIMOlGl |
|---|---|
| Voltage/Frequency | ll5V/60Hz |
| Ice-making Current | l.7A |
| Ice-harvest Current | 2.0A |
| Working Power | l60W |
| Water Reservoir | 2L(0.53gal) |
| Ice Basket Capacity | l .32LBS (0.6KG) |
| Ice Making Rate | 26LBS per day |
| Ice Shape | Bullet |
| Ice Size | Small or Large |
| Material | ABS, PP |
TROUBLESHOOTING
| Problem | Possible Causes | Solution |
|---|
Poor
ice-making result.
|
Poor heat dissipation. +
| Leave a 6-inch clearance on all sides of the ice mak
er for ventilation.
The water temperature is too high.| Fill with water temperature between 8°Cand25°C.
The ambient tempera + ture is too high.
| Use the ice maker in room
temperatures between 700c and 320c.
Evaporator deforma +
tion
| Please contact the custom er service.
Ice mak er creating noise.| The ice maker has not been cleaned for a
Song.
| Clean every l to 2 weeks,
and some neutral cleaning
agents (such as detergent
and soapy water etc.)
Lack of water to pump
will create noise when + pumping water.
| Add more water.
The fan or ice maker is damaged.
| Please contact the custom er service.
The water pump is dam aged.
Problem| Possible Causes| Solution
---|---|---
“ICE FULL”
The light is on.
| Ice is blocking the infra-,,,.. red sensor.| Empty the iceb ask et.
Infrared sensors do not work.| l. Wipe clean the infrared sensors.
2. Contact customer service if the infrared sen sors still don’t work.
Ice sticks together.
| Making ice takes too long.| Stop making ice, after the ice melts restart and try
again.
· Tht e water temperature 00 1 OW.| Fill with water tempera- turns et ween soc
and 250C.
Evaporator deforma tion.|
Please contact customer service.
Not making ice.| Amb. to water temperature.| Keep ambient temperature
less than 32OC and old fill water.
The water pump is damaged.| Please contact customer service.
Refrigerating system leaking.
Refrigerating system + blocked.
The fan stopped working.
The wires are loose
The gears in the motor are broken.
Problem| Possible Causes| Solution
---|---|---
“ADD WATER “
The light is on.
| Low water level or lack of water.| st0P making ice, refill water, press
“ON/OFF” Then restart and try again.
The water screen is blocked at the bottom of the water + reservoir.| Start the
self-cleaning function.
Pump malfunction.|
Please contact customer **** service.
The water detector mal-union.
SHORT AND LONG-TERM WARRANTY INFORMATION 30-DAY LIMITED WARRANTY
To provide customers with quality shopping and user experience, we guarantee
to replace or issue a full refund no questions asked within 30 days from the
date of purchase.
30-DAY TO 1-YEAR LIMITED WARRANTY
After the 30-day warranty has expired, Silonn automatically activates a 1-year
warranty from the date of purchase that covers product replacement- menu.
30-DAY TO 1-YEAR WARRANTY LIMITATIONS
This warranty does not cover:
- Any condition resulting from incorrect or inadequate maintenance or care.
- Damage resulting from misuse, abuse, negligence, accidents, or shipping damage.
- Dissatisfaction due to buyer’s remorse.
- Normal wear and tear.
- Damages incurred after the initial transportation.
Thank You For choosing Silonn’s Ice Maker! All of us at Silonn do appreciate your ice maker purchase. We hope that you are as happy with the ice maker as we were designing and manufacturing it for you. We strive to provide you with the best quality ice makers and services in the industry.
Questions or Problems?
support@silonn.com
Latest Information and More.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>