Silonn SLIM21G1 Ice Maker Countertop Instruction Manual

June 14, 2024
Silonn

**Silonn SLIM21G1 Ice Maker Countertop Instruction Manual


**

Thank You

For Choosing Silonn!
All of us at Silonn do appreciate your ice maker purchase. We hope that you are as happy with the ice maker as we were designing and manufacturing it for you. We strive to provide you with the best quality ice makers and services in the industry.

IMPORTANT SAFETY INFORMATION

To reduce the risk of injury or property damage, follow these safety precautions.

WARNING

  • Voltage power from outlet must match specifications on appliance nameplate.

  • This appliance must be grounded.

  • Using an extension cord may cause overheating and increase the risk of fire.
    If an extension cord MUST be used:

    1. Only use an extension cord with grounding plug.
    2. The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
  • Do not operate if any component, including the cord or plug, is damaged.

  • Unplug the unit before cleaning by hand.

  • Symbol Only responsible and capable adults should operate the ice maker.

  • Do not place the power cord where it could be pulled by children or pose a tripping hazard.

  • Children should not be left unattended near the ice maker during operation.

  • Symbol Do not use water that is micro-biologically unsafe or of un- known quality.

  • Symbol Do not remove any safety, warning, or product information la- bels from the unit.

  • Do not touch the evaporator with your hands while the ice maker is operating.

  • Do not plug in or unplug the unit with wet hands.

  • Symbol The unit must be placed and set up according to installation instructions before use. The unit is for indoor household use only.

  • Symbol Do   not store or use flammable vapors or liquids near the unit.

  • Do not immerse any part of the unit in water.

  • Symbol Do not attempt to disassemble, repair, modify or replace any part of the ice maker without permission from Silonn or its af- filiates.

WARNING

FIRE OR EXPLOSION HAZARD Flammable Refrigerant
This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to re- duce the risk of injury or property damage.

  1. Symbol When handling, installing, and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
  2. Symbol Only dispose of the unit according to Federal and Local Reg- ulations. Contact your local authorities for the environmen- tally safe disposal of the unit.
  3. Symbol Keep ventilation openings around the unit’s enclosure clear of obstruction.
  4. Symbol Do not place the unit near heat sources such as an oven.
  5. Symbol Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
  6. Symbol Do not place the unit in direct sunlight.

Product Introduction

Product Introduction

  1. Large Viewing Window
  2. Ice Full Sensor
  3. Ice Shovel
  4. Maximum Water Fill Line
  5. Air Exhaust Fan
  6. Control Panel
  7. Handle
  8. Drain Plug
  9. Ice Basket Handle
  10. Ice Basket
  11. Ice Scoop

Control Panel Introduction

Control Panel Introduction

| Key(with indicator light)| Function
---|---|---
1| ADD WATER| The indica†or ligh† †urns red when†he wa†er reservoir lacks vva†er.
2| ICE FULL| The indica†or ligh† †urns red when†he ice baske† is full.
3| S| The indica†or ligh† †urns green when small ice mode is selected.
4| L| The indica†or ligh† †urns green when large ice mode is selected.
5| ON/OFF CLEAN| Shor† press †he “ON/OFF/ CLEAN” bu††on †o †urn on †he ice maker and †he “POWER” indica-†or light †urns green.
Shor† press †he “ON/OFF/ CLEAN” bu††on †o †urn off †he ice maker and †he “POWER” indica†or flashes in green.
When †he ice maker is in s†andby mode, long-press †he “ON/OFF/ CLEAN” bu††on for 5 seconds and †he ice maker will swi†ch †o self-cleaning mode, †he indica†or Iigh†s of “S” and “L” will flash in green consecutively.
6| SELECT| Confirming large ice mode or small ice mode.

USING YOUR ICE MAKER

BEFORE FIRST USE

  1. Stand upright for 24hrs.

  2. Check for accessories.

  3. Missing parts? Contact us.

  4. Discard first 4 cycles of ice

  5. Use in locations 10°C 32°C

  6. Perfect ice shape,

Installing The Handle

  1. Position the handle over the insert hole.

  2. Fit the handle into the insert notch.

  3. Lift back to lock into place.

What Not To Do!

  1. Unstable base.

  2. No other liquids (Drinking water only).

  3. Do not use in high or low temps

HOW TO USE YOUR ICE MAKER

  1. Open cover and remove basket

  2. Pour water, do not exceed the “MAX” water mark

  3. Press the “ON/ OFF” button

  4. Press “SELECT” to choose ice cube size.
    Use your ice maker

  5. Wait 6min-13min.
    Use your ice maker

  6. Ice full and ready when “ICE FULL” indicator is on
    Use your ice maker

  7. When “ADD WATER” indicator is red, add water and press “ON/OFF
    Use your ice maker

CLEANING AND MAINTENANCE

To keep your ice tasting fresh and the unit looking great, we recom- mend cleaning the unit once per week.

MANUAL CLEANING

  1. Remove the basket.

  2. Clean using a soft cloth with warm water and vinegar, then rinse with clean water

  3. Drain excess water over sink.
    Working table 60mm
    Manual Cleaning

  4. Clean exterior with cloth using mild dish washing soap.

SELF-CLEANING (30-MIN PROCESS)

  1. Remove the basket and add water

  2. In Standby Mode Hold for 5 sec to start self-cleaning

  3. Drain Plug
    Drain excess water over sink.
    Working table 60mm
    Self Cleaning

  4. Clean exterior with cloth using mild dishwashing soap.

DO’S & DON’Ts while cleaning and maintaining

  • Do not use organic solvent, boiled water, detergent, strong acid and strong alkali etc, for cleaning.
  • When the unit is not to be used for a long duration, drain the water completely & dry the interior.
  • Store in a well ventilated area

Product Specifications

Model SLIM21B/SLIM2I/SLIM21W SLIM 2IT
Voltage/Frequency ll5V/6OHz I15V/6OHz
Ice-making Current l.5A 1.5A
Ice-harvesting Curren† 1.8A I .8A
Working Power sl6OVV sl6OVV
Water Reservoir 1.2L 1. 2L
Ice Basket Capacity l .32 Ibs (O.6 VG) I .Z2 I bs (O.6KG)
Ice-making Rate 26 lbs per day 26 Ibs per day
Ice Shape Bulle† Bulle†
Ice Size Small or Large Small or Large
Material ABS, PP ABS, PP,S†ain less S†eel
Ne† Weigh† 13.7lbs (6.2KG) I Z.9 Ibs (6. 3 VG)
Produc† Size 8.7x l1.4x 1l.6inch(222x29ox294rni) 8.7 x 1l.4 x 11.6

inch (222 x 29O x 294 mm

Troubleshooting

Problem Possible Causes Solution
Poor ice shape or qualify. Poor hea† dissipation. Leave a 6-inch clearance

on all sides of †he ice mak- er for ven†iIa†ion.
The wa†er †empera†ure is †oo high.| Fill wi†h wa†er †em pera†ure between 8°C and 25°C.
The ambien††empera†ure is †oo high.| Use †he ice maker in room†empera†ures between IO°C and 32°C.
Evapora†or deformation| Please con†ac† customer service.
Ice maker creating loud noise.| Ice maker has no† been cleaned for a long†ime, which will form a s†icky subs†ance around †he inIe† of †he wa†er pump.| Clean every 1 †o 2 weeks, using some neutral cleaning agen†s (such as mild vinegar solution and soapy wa†er e†c.)
Lack of wa†er †o pump will crea†e noise when pumping wa†er.| Add more wa†er.
Fan or ice-maker is damaged.| Please con†ac† customer service.
Wa†er pump is damaged.
Problem| Possible Causes| Solution
---|---|---
“ICE FULL”light is on.| Ice is blocking †he infra- red sensor.| Emp†y †he ice baske†.
Infrared sensors do no† work.| 1.    Wipe clean †he infrared sensors.2. Con†ac† customer ser- vice if †he infrared sen- sors s†iII don’† work.
Ice sticks together.| Making ice †akes †oo long.| S†op making ice, af†er †he ice meI†s res†ar† and †ry again.
The wa†er †empera†ure is †oo low.| Fill wi†h wa†er †empera-†ures between 8°C and 25°C.
Evaporator deformation.| Please contact customer service.
Not making ice.| Ambien† or wa†er†empera†ure is †oo high.| keep ambien† †empera†ure less †han 32°C and fill wi†h cold wa†er.
Wa†er pump is damaged.| Please contact customer service.
Refrigerating sys†em leaking.
Refrigerating sys†em blocked.
The fan s†opped working.
The wires are loose.
The gears in †he mo†or are broken.
Problem| Possible Causes| Solution
---|---|---
“ADDWATER”light is on.| Low wa†er level or lack of wa†er.| S†op making ice, refill wa†er, press “ON/OFF”,†hen res†ar† and †ry again.
Wa†er screen blocked a††he bo††om of†he wa†er reservoir.| S†ar† †he self cleaningfunction.
Pump malfunction.| Please contact customer service.
Wa†er de†ec†or malfunction.

SHORT AND LONG-TERM WARRANTY INFORMATION

30-DAY LIMITED WARRANTY

To provide customers with a quality shopping and user experience, the unit can be replaced or returned for a full refund within the 30-day period from the date of purchase.

30-DAY TO 1-YEAR LIMITED WARRANTY

After the 30-day warranty has expired, Silonn automatically activates a 1-year warranty from the date of purchase that covers product replacement.

30-DAY TO 1-YEAR WARRANTY LIMITATIONS

This warranty does not cover:

  • Any condition resulting from incorrect or inadequate maintenance or care.
  • Damage resulting from misuse, abuse, negligence, accidents, or shipping damage.
  • Dissatisfaction due to buyer’s remorse.
  • Normal wear and tear.
  • Damages incurred after initial transportation.

Questions or Problems?

support@silonn.com
877-546-8603
 support@silonn.com

Silonn Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals