Silonn SLIM25B Countertop Ice Maker Machine Instruction Manual
- June 14, 2024
- Silonn
Table of Contents
Silonn SLIM25B Countertop Ice Maker Machine
IMPORTANT SAFETY INFORMATION
To reduce the risk of injury or property damage, please follow these safety precautions.
WARNING
-
Voltage power from outlet must match specifications on appliance nameplate.
-
This appliance must be grounded.
-
Using an extension cord may cause overheating and increase the risk of fire.
If an extension cord MUST be used:- Only use an extension cord with grounding plug.
- The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
-
Do not operate if any component, including the cord or plug, is damaged.
-
Unplug the unit before cleaning by hand.
-
Only responsible and capable adults should operate the ice maker.
-
Do not place the power cord where it could be pulled by children or pose a tripping hazard.
-
Children should not be left unattended near the ice maker during operation.
-
Do not use water that is microbiologically unsafe or of unknown quality.
-
Do not remove any safety, warning, or product information labels from the unit.
-
Do not touch the evaporator with your hands while the ice maker is operating.
- Do not plug in or unplug the unit with wet hands.
-
The unit must be placed and set up according to installation instructions before use. The unit is for indoor household use only.
-
Do not store or use flammable vapors or liquids near the unit.
- Do not immerse any part of the unit in water.
-
Do not attempt to disassemble, repair, modify or replace any part of the ice maker unless permitted by the manufacturer.
WARNING
FIRE OR EXPLOSION HAZARD Flammable Refrigerant This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.
- When handling, installing, and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
- Only dispose of the unit according to Federal and Local Regulations. Contact your local authorities for the environmentally safe disposal of the unit.
- Keep ventilation openings around the unit’s enclosure clear of obstruction.
- Do not place the unit near heat sources such as an oven.
- Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
- Do not place the unit in direct sunlight.
PRODUCT INTRODUCTION
- Large Viewing Window
- Ice Shovel
- Ice Full Sensor
- Handle
- Air Exhaust Fan
- Control Panel
- Maximum Water Fill Line
- Drain Plug
- Filter
- Ice Basket
- Ice Scoop
CONTROL PANEL INTRODUCTION
| Key (with indicator)| Function
---|---|---
1| | ** indicator light flashes when powering up but remains on when
in working mode
2| |
indicator
light is on when large ice cube mode is selected
3| |
indicator
light is on when small ice cube mode is selected
4| | indicator light is on when the ice basket is ready and full
5| | indicator light is on when the water reservoir is low
6| | indicator light is on when the ice maker is in self-cleaning mode
7| SELECT| Press SELECT button to switch between , or
8| ON/OFF| Press ON/OFF** button to power the ice maker on or
turn it off
USING YOUR ICE MAKER
BEFORE FIRST USE
-
Stand upright for 24 hrs. Check for accessories.
Missing parts? Contact us.
-
Clean the ice maker thoroughly before first use.
Discard first 4 cycles of ice.
Use in locations S0°F ~ 90°F.
Perfect ice shape.
More Cycles = Perfect Shape
Due to temperature variations and other factors, ice production would be stable after 1-3 initial cycles.
-
Align the handle with the keyholes.
Insert each side into the keyholes.
Lift handle back to lock in place.
-
What Not To Do!
Unstable base.
No other liquids (Drinking water only).
Do not use in high or low temps.
HOW TO USE YOUR ICE MAKER
Open cover and remove basket.
Pour water, do not exceed the “MAX” water mark.
Press the ON/OFF button.
Press SELECT button to choose ice cube size.
Wait for 6min-73min.
indicator light is on when ice basket is full and ready.
When indicator light is on, add water and press ON/OFF button to restart.
Take ice cubes out in time to avoid melting.
CLEANING AND MAINTENANCE
To keep your ice tasting fresh and the unit looking great, we recommend cleaning the unit once per week.
SELF-CLEANING (5-MIN PROCESS)
-
Remove the basket and add water.
-
Press SELECT button to choose . Then press ON/OFF button to start self-cleaning mode.
-
Drain water reservoir.
-
Clean exterior with cloth and mild dishwashing soap.
MANUAL CLEANING
Turn off the unit and disconnect from power outlet before cleaning.
-
Remove the basket.
-
Clean using a soft cloth with warm water and vinegar. Clean the water filter, ice shovel and the evaporator to avoid dirt buildup.
-
Drain water reservoir.
-
Clean exterior with cloth and mild dishwashing soap.
DO’s &. DON’Ts while cleaning and maintaining
- Do not use organic solvent, boiled water, detergent, strong acid and strong alkali etc. for cleaning.
- When the unit is not to be used for a long duration, drain the water completely & dry the interior.
- Store in a well ventilated area.
PRODUCT SPECIFICATIONS
Model | SLIM25B/SLIM25G |
---|---|
Voltage/Frequency | 120V/60Hz |
Working Power | 105W |
Electric Current | 1.7 A |
Water Reservoir | 0 . 32 gal (l . 2L) |
Ice Basket Capacity | 1.1 lbs (0 .5 KG) |
Ice-Making Rate | 26 lbs per Day |
Ice Shape | Bullet |
Ice Size | Small or Large |
Material | ABS, PP |
Net Weight | 13 .6 lbs (6.2KG) |
Unit Size | 11.9 x 9.8 x 11.l Inch (303 x 249 x 282 mm) |
TROUBLESHOOTING
Problem | Possible Causes | Solution |
---|---|---|
Poor ice shape or quality. | Poor heat dissipation. | Leave a 6-inch |
clearance on all sides of the ice maker for ventilation.
The water temperature is too high .| Fill with water temperature between 46°F
and 77°F.
The ambient temperature is too high.| Use the ice maker in room temperatures
between 50°F and 90°F.
Evaporator deformation.| Please contact customer service .
Ice maker creating loud noise.| Ice maker has not been cleaned for a
long time, which will form a sticky substance around the inlet of the water
pump.| Clean every l to 2 weeks, using some neutral cleaning agents (such as
mild vinegar solution and soapy water).
Lack of water to pump will create noise when pumping water.| Add more water.
Fan or ice maker is damaged.| Please contact customer service.
Water pump is damaged.
Problem| Possible Causes| Solution
---|---|---
indicator light
turns on.| Ice is blocking the infrared sensor.| Empty the ice basket .
Infrared sensors do not work.|
- Wipe the infrared sensors clean.
- Contact customer service if the infrared sensors still don’t work.
Ice sticks together.| Making ice takes too long.| Stop making ice. After
the ice melts, restart and try again.
The water temperature is too low.| Fill with water tern- peratures between
46°F and 77°F.
Evaporator deformation.| Please contact customer service.
Not making ice.| Ambient or water temperature is too high.| Keep ambient
temperature less than 90°F and fill with cold water.
Water pump is damaged.| Please contact customer service.
Refrigerating system leaking.
Refrigerating system blocked.
The fan stopped working.
The wires are loose.
The gears in the motor are broken.
Problem| Possible Causes| Solution
---|---|---
indicator light turns on.| Low water level or not enough water .| Stop making
ice, refill water, press ON/OFF button, then restart and try again.
Water screen blocked at the bottom of the water reservoir.| Start the self-
cleaning function.
Pump malfunction.| Please contact customer service.
Water detector malfunction.
WARRANTY INFORMATION
30-DAY LIMITED WARRANTY
To provide customers with a quality shopping and user experience, the unit can be replaced or returned for a full refund within the 30- day period from the date of purchase.
30-DAY TO 1-YEAR LIMITED WARRANTY
After the 30-day warranty has expired, a 7-year warranty from the date of purchase that covers product replacement is automatically activated. Please note that proof of purchase is required for all warranty claims.
30-DAY TO 1-YEAR WARRANTY LIMITATIONS
This warranty does not cover:
- Any condition resulting from incorrect or inadequate maintenance or care.
- Damage resulting from misuse, abuse, negligence, accidents, or shipping damage.
- Dissatisfaction due to buyer’s remorse.
- Normal wear and tear.
- Damages incurred after initial transportation.
Thank You
For Choosing Us!
All of us do appreciate your ice maker purchase. We hope that you are as happy with the ice maker as we were designing and manufacturing it for you. We strive to provide you with the best quality ice makers and services in the industry.
Customer Support
Questions or Problems?
help_service_center@outlook.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>