Silonn SLIM21B Countertop Portable Ice Maker Instruction Manual

Silonn SLIM21B Countertop Portable Ice Maker

IMPORTANT SAFETY INFORMATION

To reduce the risk of injury or property damage, please follow these safety precautions.
WARNING

• Voltage power from the outlet must match the specifications on the appliance nameplate.

• This appliance must be grounded.

• Using an extension cord may cause overheating and increase the risk of fire.
  If an extension cord MUST be used:

  • Only use an extension cord with a grounding plug.
  • The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
  • Do not operate if any component, including the cord or plug, is damaged.
  • Unplug the unit before cleaning it by hand.

• Only responsible and capable adults should operate the ice maker.

• Do not place the power cord where it could be pulled by children or pose a tripping hazard.

• Children should not be left unattended near the ice maker during operation.

• Do not use water that is micro-biologically unsafe or of unknown quality.

• Do not remove any safety, warning, or product information labels from the unit.

• Do not touch the evaporator with your hands while the ice maker is operating.

• Do not plug in or unplug the unit with wet hands.

• The unit must be placed and set up according to installation instructions before use. The unit is for indoor household use only. Do not store or use flammable vapors or liquids near the unit.

• Do not immerse any part of the unit in water.

• Do not attempt to disassemble, repair, modify or replace any part of the ice maker unless permitted by the manufacturer.

WARNING

• FIRE OR EXPLOSION HAZARD Flammable Refrigerant This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.

1. When handling, installing, and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
2. Only dispose of the unit according to Federal and Local Regulations. Contact your local authorities for the environmentally safe disposal of the unit.
3. Keep ventilation openings around the unit’s enclosure clear of obstruction.
4. Do not place the unit near heat sources such as an oven.
5. Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
6. Do not place the unit in direct sunlight.

PRODUCT INTRODUCTION

1. Large Viewing Window
2. Ice Full Sensor
3. Ice Shovel
4. Maximum Water Fill Line
5. Air Exhaust Fan
6. Control Panel
7. Handle
8. Drain Plug
9. Ice Scoop Holder
10. Ice Basket
11. Ice Scoop

CONTROL PANEL INTRODUCTION

ADD WATER

| The indicator light turns red when the water reservoir is low.
ICE FULL| The indicator light turns red when the ice basket is full.
POWER| The indicator light turns green when on and flashes when powering up or down.
s| The indicator light turns green when small ice mode is selected.
L| The indicator light turns green when large ice mode is selected.
ON/OFF CLEAN| Short press the ON/OFF button to turn the ice maker on.
Short press the ON/OFF button to turn the ice maker off.
In standby mode, press and hold the ON/OFF/CLEAN button for 5 seconds to enter self-cleaning mode. The indi­ cator lights of “S” and “L” will flash in green consecutively.
SELECT| Confirms large ice mode or small ice mode.

USING YOUR ICE MAKER

BEFORE FIRST USE

1. Stand upright for 24hrs.
   • Check for accessories.
   • Missing parts?  Contact us.
2. Clean the ice maker thoroughly before first use.
   • Discard first 4 cycles of ice.
   • Use in locations 509F ~ 90°F.
   • Perfect ice shape.
3. Installing The Handle
   • Position the handle over the insert hole.
   • Fit the handle into the insert hole.
   • Lift back to lock into place.
4. What Not To Do!
   • Unstable base.
   • No other liquids (Drinking water only).
   • Do not use in high or low temps.

HOW TO USE

HOW TO USE YOUR ICE MAKER

1. Open the cover and remove the basket.
2. Pour water, do not exceed the “MAX” watermark.
3. Press the ON/OFF button.
4. Press the SELECT button to choose the ice cube size.
5. Wait 6min-13min.
   • Ice full and ready when the “ICE FULL” indicator is on.
   • When the “ADD WATER” indicator is red, add water and press the ON/OFF button.
   • Take ice cubes out in time to avoid melting.

CLEANING AND MAINTENANCE

To keep your ice tasting fresh and the unit looking great, we recommend cleaning the unit once per week.

SELF-CLEANING (30-MIN PROCESS)

1. Remove the basket and add water to the “MAX” water level.
2. Press and hold ON/OFF/CLEAN button for 5 sec to start self-cleaning.

MANUAL CLEANING

Turn off the unit and disconnect from power outlet before cleaning.

1. Remove the basket.
2. Clean using a soft cloth with warm water and vinegar. Clean the water filter, ice shovel and the evaporator to avoid dirt buildup.
3. Drain water reservoir.
4. Clean exterior with cloth and mild dishwashing soap.

A DO’s & DON’Ts while cleaning and maintaining

• Dong alien to deant, bolled water, detergent, strong acid and
• When the unit is not to be used for a long duration, drain the water completely & dry the interior.
• Store in a well-ventilated area.

PRODUCT SPECIFICATIONS

TROUBLESHOOTING

Poor ice shape or quality.

|

Poor heat dissipation.

| Leave a 6-inch clearance on all sides of the ice mak­ er for ventilation.

The water temperature is too high.

|

Fill with water temperature between 46°F and 77°F.

The ambient temperature is too high.

| Use the ice maker in room temperatures between 50°F and 90°F.

Evaporator deformation.

|

Please contact customer service.

Ice maker creating loud noise.

|

Ice maker has not been cleaned for a long time, which will form a sticky substance around the inlet of the water pump.

|

Clean every l to 2 weeks, using some neutral cleaning agents (such as mild vinegar solution and soapy water etc.)

Lack of water to pump will create noise when pumping water.

|

Add more water.

Fan or ice maker is damaged.

|

Please contact customer service.

Water pump is damaged.

“ICE FULL”

indicator light is on.

| Ice is blocking the infrared sensor.| Empty the ice basket.

Infrared sensors do not work.

| Wipe clean the infrared sen­ sors, or long press the SELECT button for 5 seconds to force the ice maker to cycle around 10 times.

Contact customer service if the infrared sensors still don’t work.

Ice sticks together.

| Making ice takes too long.| Stop making ice, after the ice melts restart and try again.
The water tempera­ ture is too low.| Fill with water temperatures between 46°F and 77°F.
Evaporator deformation.| Please contact customer service.

Not making ice.

| Ambient or water temperature is too high.| Keep ambient temperature less than 90°F and fill with cold wa­ ter.
Water pump is damaged.|

Please contact customer service.

Refrigerating system leaking.
Refrigerating system blocked.
The fan stopped working.
The wires are loose.
The gears in the motor are broken.
Problem| Possible Causes| Solution
---|---|---

“ADD

|

Low water level or need of water.

| Stop making ice, refill wa- ter, press ON/OFF button, then restart and try again.
 |
WATER”

indicator light is on

| Water screen blocked at the bottom of the water reservoir.|

Run the self-cleaning cycle.

 | Pump malfunction.|

Please contact customer service.

Water detector malfunction.

WARRANTY INFORMATION

30-DAY LIMITED WARRANTY

• To provide customers with a quality shopping and user experience, the unit can be replaced or returned for a full refund within the 30-day period from the date of purchase.

30-DAY TO 1-YEAR LIMITED WARRANTY

• After the 30-day warranty has expired, a 1-year warranty from the date of purchase that covers product replacement is automatically activated. Please note that proof of purchase is required for all warranty claims.

30-DAY TO 1-YEAR WARRANTY LIMITATIONS

This warranty does not cover:

• Any condition resulting from incorrect or inadequate maintenance or care.
• Damage resulting from misuse, abuse, negligence, accidents, or shipping damage.
• Dissatisfaction due to buyer’s remorse.
• Normal wear and tear.
• Damages incurred after initial transportation.

Thank You For Choosing Us! All of us do appreciate your ice maker purchase. We hope that you are as happy with the ice maker as we were designing and manufacturing it for you. We strive to provide you with the best quality ice makers and services in the industry.

• Questions or Problems?
  • 877-201-4016
  • help_service_center@outlook.com.
  • 860-00630-00 Rev05
  • help_service_center@outlook.com.
  • & 877-201-4016

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>